Abstract:A method based on thermal desorption-gas chromatography-mass spectrometry (TD GC -MS) was developed for the simultaneous analysis of 67 volatile organic compounds (VOCs) in ambient air. In this study, the adsorption effects of five kinds of stainless steel sorbent tubes for 78 VOCs were compared. The results revealed that a multisorbent bed with Carbograph 1TD and Tenax TA shows good adsorption effect for the 67 target compounds. The breakthrough rates of all the target compounds were less than 10% when high-purity helium gas was continuously purged for 45 min at 30 mL/min. The analytes included aromatic hydrocarbons, aliphatic hydrocarbons, halogenated hydrocarbons, and oxygen-containing volatile organic compounds. The thermal desorption conditions for the determination of the target substances were optimized. In the range 5 -100 ng, the chromatographic response of the target compounds had a good linear relationship with their corresponding amounts, and the correlation coefficient (r) was between 1. 000 0 and 0. 997 7. The method detection limits ( MDLs) were 0. 3-2. 4 ng or 0. 3 -2. 4 mu g/m(3), as calculated by a 1 L sampling volume. The method was validated by means of recovery experiments (n =7) with the addition of 20 ng standard samples. The recoveries of all the target compounds were in the range of 81. 6% -114. 9%, and their relative standard deviations (RSDs) were in the range of 1. 2%-10. 2%. The VOCs present in the air in a carriage were detected using this method. The 19 target compounds included esters, halogenated alkanes, halogenated olefins, and aromatic substances, whose concentrations ranged from 1. 1 to 84. 1 g/m3. These results indicated that our method is accurate, reliable, and sensitive, and can allow for accurate quantification of the 67 target pollutants in ambient air.

Development of A Fiber-Packed In-Tube Extraction Device and Its Application in BTEX Analysis

Evaluation of the solid-phase microextraction fiber coated with single walled carbon nanotubes for the determination of benzene, toluene, ethylbenzene, xylenes in aqueous samples.

PDMS-coated Γcd-Mof Solid-Phase Microextraction Fiber for BTEX Analysis with Boosted Performances.

MOF-801 based solid phase microextraction fiber for the monitoring of indoor BTEX pollution

Field analysis of benzene, toluene, ethylbenzene and xylene in water by portable gas chromatography-microflame ionization detector combined with headspace solid-phase microextraction.

Determination Of 67 Volatile Organic Compounds In Ambient Air Using Thermal Desorption-Gas Chromatography-Mass Spectrometry

Concentrically Packed High Flow Air Sampler for Parts-Per-trillion Volatile and Semi-Volatile Organica Compounds

Preparation and Characterization of Metal-Organic Framework MIL-101(Cr)-coated Solid-Phase Microextraction Fiber

[Target and Non-Target Screening of Volatile Organic Compounds in Industrial Exhaust Gas Using Thermal Desorption-Gas Chromatography-Mass Spectrometry].

Disposable ionic liquid coating for headspace solid-phase microextraction of benzene, toluene, ethylbenzene, and xylenes in paints followed by gas chromatography-flame ionization detection.

Evaluating BTEX in vehicle exhaust gas: A fast and efficient approach using SPME and GC-BID

Preparation of a Carbon-Coated SPME Fiber and Application to the Analysis of BTEX and Halocarbons in Water

Determ Ination of Low Concentration VOCs in Air by a Newly Designed Needle Trap Device

Determination of benzene, toluene, ethylbenzene, and p-xylene with headspace-hollow fiber solid-phase microextraction-gas chromatography in wastewater and Buxus leaves, employing a chemometric approach

Development of Octadecyl-Functionalized-Nanotubular Tio2/Ti Wire Solid-Phase Microextraction Fiber

Investigation of a Novel Activated Carbon Coating Fiber Used for Solid Phase Micro-Extraction

Carbon nanospheres covalently modified with polydimethylsiloxane on a porous sol–gel support for use in headspace solid-phase fiber microextraction of BTEX

Refrigerated sorptive extraction: determination of BTEX in water samples

Hybrid Separation and Detection Device for Analysis of Benzene, Toluene, Ethylbenzene, and Xylenes in Complex Samples

Sample Bottle Coated with Sorbent As a Novel Solid-Phase Extraction Device for Rapid On-Site Detection of BTEX in Water

Portable automatic BTX measurement system with microfluidic device using mesoporous silicate adsorbent with nano-sized pores