Abstract:This article reports a high-gain wideband low-noise amplifier (LNA) with single ended input and differential output for multi-standard wireless receiver operating in 0.2 to 7 GHz. The proposed balun-LNA is cascode structure with common-gate–common-source (CG–CS) balun load to achieve single to differential conversion. Focusing on improving the voltage gain, bandwidth and noise performance at the same time, several techniques are implemented in this balun-LNA. A current source is added shunting CG stage to relieve voltage headroom and improve gain and linearity. Wideband input matching is achieved by active shunt-shunt resistive feedback, together with the input series inductor. Moreover, feedforward and current-reuse technique are introduced to further optimize the noise performance. The proposed LNA has a measured voltage gain of 26 dB which is nearly 6 dB higher than other balun-LNA with same supply and process. Moreover, the minimum noise figure (NF) is 2.0 dB owing to multiple noise-optimized technique. The achieved input power at 1 dB gain compression point (IP1 dB) is −14 dB m at 1 GHz and input return loss ( S11 ) is better than −10 dB across entire operating frequency range. IIP3 and IIP2 achieve −7 dBm and 25 dBm respectively, measured at 1 GHz. The power consumption is 15.5 mW at 1.2 V supply. The LNA is fabricated in 130 nm CMOS process and the active area is 0.097 mm2 . The LNA achieves high voltage gain and wide operating frequency range with low NF, which can be reflected from the figure of merit (FOM) of 23.1.

Design Analysis of Integrated Passive Device-Based Balun Devices with High Selectivity for Mobile Application

Compact CMOS Baluns for the 4–10 GHz Band Applications

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

A Compact 1.08–5.94 GHz Balun with 1○/0.07 Db Phase-/Amplitude-Imbalances Using Reverse Series Paths

1.34-To-16.37 GHz On-Chip Balun Based on Asymmetric Stacked Spiral Transformers

Low-loss Balun Design and Compact Modeling for RF/millimeter-wave Circuit Application

Design and Experimental Validation of Highly Compact Branch-Line Balun for Quad-Band Applications

Compact Wideband Balun Using Hybrid Folded Substrate Integrated Waveguide/Slotline Resonator

Research on miniaturized balun in RF front end

800Mhz~2.5ghz Miniaturized Multi-layer Symmetrical Stacked Baluns for Silicon Based RF ICs

An Area-Saving Balun for Multiband IoT Transmitter

Design of Integrated Differential Balun Circuits

Low Loss W-Band Packaged Filtering Balun Based on a Modified Quarter-Mode Folded Substrate-Integrated Waveguide Cavity

Input-Reflectionless 2.4–3.8 GHz Balun With Low Phase/Amplitude Imbalance Using Stacked-Coupled Microstrip Line

The Design of a Wideband Microstrip Marchand Balun

Design and modeling of an on-chip asymmetric tap balun for CMOS millimeter-wave circuits

Planar Compact Dual-Band Balun with Flexible Frequency Ratios

A high-gain wideband balun-LNA with multiple noise-optimized technique

Three Compact Active Baluns with High Phase/Amplitude Balance and Low Power in 65-nm CMOS for Transceiver Applications

An Advanced Broadband Absorptive Balun for Modern Communication Systems

Compact 6.5-28.5 GHz On-Chip Balun with Enhanced Inband Balance Responses