Abstract:Double-pipe heat exchangers are widely used in the high-pressure and high-temperature applications for their simple and tight tube-in-tube configuration, but therefore normal and stable operation of such pressure-bearing equipment turns to be of greater significance because potential safety risks and economic losses will be aroused if failures occur on them. To deal with this issue, abundant researches have been conducted so far, however most of them focused on the flow and fluid characteristics by numerical simulation and experimental verification, while little attention was paid to the actual cases from the engineering practice. In this paper, such an actual failure case study concerning leakage on the jacket pipe of one double-pipe heat exchanger in a high-pressure polyethylene facility is addressed. In order to find out the causes of this failure, investigation including materials inspection, chemical phase analysis, microscopic morphologies observation, micro-area chemical compositions detection and finite element analysis etc. was carried out. The results indicated that the leakage was firstly induced by the uniform corrosion and the under-deposit corrosion successively, and then stimulated by the effect of erosion from the complicated fluid characteristics around the tee structure. Finally, the related mechanisms of this synergistic effect between corrosion and erosion were discussed, and the pertinent countermeasures from both design and maintenance point of view were proposed, including descaling of the fouled inner pipe, improvement of the circulation cooling water quality, and upgrading of the pipe materials etc. Achievement of this paper will supplement the failure cases database of double-pipe heat exchangers, based on which design optimization and failure prevention will be possible.

Failure analysis on leaked titanium tubes of seawater heat exchangers in recirculating cooling water system of coastal nuclear power plant

Failure Analysis of Leakage on Titanium Tubes Within Heat Exchangers in a Nuclear Power Plant. Part II: Mechanical Degradation

Failure Analysis and Countermeasure of Heat Exchangers in Nuclear Power Facility

Failure Analysis on Abnormal Wall Thinning of Heat-Transfer Titanium Tubes of Condensers in Nuclear Power Plant Part II: Erosion and Cavitation Corrosion

Failure Analysis on Abnormal Leakage Between Tubes and Tubesheet of Spiral-Wound Heat Exchanger for Nuclear Power Plant

Materials and Corrosion 1/2012

Failure Analysis on Abnormal Bursting of Heat Transfer Tubes in Spiral-Wound Heat Exchanger for Nuclear Power Plant

Failure Analysis on Abnormal Leakage of Shell and Tube Heat Exchanger in Specialty Chemical Plant

The Failure Mechanism of the 316 SS Heat Exchanger Tube in the Geothermal Water Environment

Failure Analysis of Stainless Steel Heat Exchanger Tubes in a Petrochemical Plant

Failure analysis of titanium heater tubes and stainless steel heat exchanger weld joints in nitric acid loop

Failure Analysis on Abnormal Leakage of TP321 Stainless Steel Pipe in Hydrogen-Eliminated System of Nuclear Power Plant

Failure Analysis on Unexpected Fracture of the Hydraulic Expansion Mandrel for Tube to Tubesheet Expanding in the Steam Generator of Nuclear Power Plant

Corrosion Failure Analysis for Heat Transfer Tube in Quick Cooled Oil-Dilute Steam Heat Exchanger

The Root Caused Analysis of Leakaged Heat Exchanger Tube

Failure Analysis on Premature Fracture of Anchor Bolts in Seawater Booster Pump of Nuclear Power Plant

Failure Analysis on Leaked Jacket Pipe of Double-Pipe Heat Exchanger in High-Pressure Polyethylene Facility

Failure analysis of heat exchange tubes in hydrogenation unit

Failure Analysis on Unexpected Perforation of Heat Exchanger Tube in Methacrylic Acid Reboiler of Specialty Chemical Plant

Failure analysis on fracture causes of stainless-steel studs in seawater system of nuclear power plants