Abstract:Tungsten grid thin-wall structures are extensively utilized as ray filtering parts in medical equipment and nuclear industries. In this work, tungsten grid thin-wall structures with a wall thickness of approximately 100 μm were fabricated via laser powder bed fusion (LPBF) additive manufacturing technology. Post-treatments were employed to suppress the defects generated in LPBF-printed tungsten grid thin-wall structures, and the mechanisms of the defect formation and suppression were discussed. The adhesions attached to the wall surface were effectively eliminated by employing chemical corrosion and sandblasting, resulting in improved values of top and lateral surface roughness at 6.4 μm and 1.65 μm, respectively. The thin-wall structure annealed at 1400 °C presented the highest relative density of 98.28 % and unique microstructure with its lateral surface exhibiting elongated columnar grains in thin wall areas. Micro-defects including pores and cracks were observed around grain boundaries. The micro-defects deteriorated when annealed below the recrystallization temperature of 1300 °C, whereas they were effectively suppressed when annealed at 1400 °C. Consequently, this sample group exhibited exceptional mechanical properties. The stress experienced during the initial collapse in compression testing of the thin-wall structures annealed at 1400 °C was calculated to be 100.61 MPa. Subsequently, through a nano-indentation testing, the hardness and Young's modulus were measured as 9.15 GPa and 153.41 GPa respectively in thin-wall area, while in intersection area they were measured as 9.96 GPa and 381.44 GPa. The enhancement in mechanical properties of annealed tungsten grid thin-wall structures was attributed to gas pore release, diffusion densification and reduced residual stress.

High-density Tungsten Fabricated by Selective Laser Melting: Densification, Microstructure, Mechanical and Thermal Performance

Selective Laser Melting of High-Performance Pure Tungsten: Parameter Design, Densification Behavior and Mechanical Properties

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Dense Pure Tungsten Fabricated by Selective Laser Melting

Densification, Microstructure And Properties Of 90w-7ni-3fe Fabricated By Selective Laser Melting

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Selective laser melting fabricated tungsten with thin-walled structure: role of linear energy density on temperature evolution and manufacturing quality

Achieving high-performance pure tungsten by additive manufacturing: Processing, microstructural evolution and mechanical properties

Simulation and Experimental Investigation on Additive Manufacturing of Highly Dense Pure Tungsten by Laser Powder Bed Fusion

Study on forming process and performance of nano-La 2 O 3 reinforced tungsten-based composites by selective laser melting

Mechanical Properties of a Novel Tungsten Fiber-Reinforced Tungsten Composite Prepared Through Powder Extrusion Printing and High-Pressure High-Temperature Sintering

Selective Electron Beam Melting (SEBM) of Pure Tungsten: Metallurgical Defects, Microstructure, Texture and Mechanical Properties

Densification, microstructural evolutions of 90W-7Ni-3Fe tungsten heavy alloys during laser melting deposition process

High compression strength pure tungsten fabricated by plasma arc additive manufacturing

Defect formation mechanism and suppression strategy in additively manufactured tungsten grid thin-wall structures via laser powder bed fusion

Formation and Extreme Thickness Controlling Mechanism of Ultra-Thin-wall Tungsten Grids Fabricated Via Selective Laser Melting

Fabrication of High-Density Microarchitected Tungsten via DLP 3D Printing

Hierarchical Microstructures Enabled Excellent Low-Temperature Strength-Ductility Synergy in Bulk Pure Tungsten

Microstructure and mechanical behavior of porous tungsten skeletons synthesized by selected laser melting

Balling Phenomena in Selective Laser Melted Tungsten

A review of tungsten fabricated via laser powder bed fusion