Abstract:Annealing Mg-implanted homoepitaxial GaN at temperatures above 1400 °C eliminates the formation of inversion domains and leads to improved dopant activation efficiency. Extended defects, in the form of inversion domains, contain electrically inactive Mg after post-implantation annealing at temperatures as high as 1300 °C (one GPa N2 overpressure), which results in a low dopant activation efficiency. Triple-axis x-ray data reveal that implant-induced strain is fully relieved after annealing at 1300 °C for 10 min, indicating that strain-inducing point defects formed during implantation have reconfigured and inversion domains are formed. However, annealing at temperatures of 1400–1500 °C (one GPa N2 overpressure) eliminates the presence of the inversion domains. While residual defects, such as dislocation loops, still exist after annealing at and above 1400 °C, chemical analysis at multiple dislocation loops shows no sign of Mg segregation. Meanwhile, an overall decreasing trend in the dislocation loop density is observed after annealing at the higher temperatures and longer times. Additionally, once inversion domains are formed and the samples are cooled to room temperature, they are shown to dissolve with subsequent annealing above 1400 °C. While such defects have been observed before, the important finding that such defects can be dissolved with a short, higher temperature step is key. Earlier work [Breckenridge et al., J. Appl. Phys. Lett. 118, 022101 (2021)] addressing electrical measurements of these types of samples showed that annealing at 1400 °C leads to a dopant activation efficiency that is an order of magnitude higher than that observed at 1300 °C. This work complements earlier work by identifying the inversion domains, which incorporate Mg, and points to the benefits, in terms of defect density and p-type dopant activation, of using higher temperature (>1400 °C) annealing cycles to activate Mg in GaN, even if the Mg-containing inversion domains had been formed during lower temperature annealing.

Capacitively Coupled Plasma-Stimulated Room-Temperature Mg and Mn Doping and Electrical Activation in GaAs

Ultra-Shallow Doping of GaAs with Mg, Cr, Mn and B Using Plasma Stimulated Room-Temperature Diffusion

Modulation of Interfacial and Electrical Properties of Hfgdo/Gaas Gate Stacks by Ammonium Sulfide Passivation and Rapid Thermal Annealing

High Mg activation in implanted GaN by high temperature and ultrahigh pressure annealing

Doping Si, Mg and Ca into GaN based on plasma stimulated room-temperature diffusion

Highly effective activation of Mg-implanted p-type GaN by ultra-high-pressure annealing

Properties of Mg-Doped AlGaN Films

Doping Characteristics of Mg in InGaAlP and GaP

Influence of High Mg Doping on the Microstructural and Opto-Electrical Properties of AlGaN Alloys

Dissolution of Mg-enriched defects in implanted GaN and increased p-type dopant activation

(Invited) Understanding Mg-Related Defects for Vertical GaN p-n Junction Structures Via p-Type Ion Implantation

Mg acceptors activation mechanism and hole transport characteristics in highly Mg-doped AlGaN alloys

Overcoming the doping limit in GaAs by ion implantation and pulsed laser melting

Atomic-scale investigation of implanted Mg in GaN through ultra-high-pressure annealing

Enhanced annealing, high Curie temperature and low-voltage gating in (Ga,Mn)As: A surface oxide control study

Property Manipulation Through Pulsed Laser Annealing in High Dose Mg-implanted GaN

Investigation Of Mg Doping In High-Al Content P-Type Alxga1-Xn (0.3 < X < 0.5)

Raising TC of Ferromagnetic Semiconductors Through Doping Control: the Case of GaMnAs

Effects of low-temperature annealing on net doping profile of Mg-ion-implanted GaN studied by MOS capacitance–voltage measurement

Optimization and Analysis of Magnesium Doping in MOCVD Grown p-GaN

Process engineering of GaN power devices via selective-area p-type doping with ion implantation and ultra-high-pressure annealing