Abstract:To respond the China’s “14th Five-Year Plan” on the control of nitrogen oxides (NOX) emission, urea-based selective catalytic reduction (SCR) system has been widely applied to reduce the NOX emission from the diesel engine. NO2 is no longer a factor to be ignored while refining the SCR-DeNOX system model because of the ship diesel engine's long-term low temperature and oxygen-rich condition, which provides abundant conditions for the creation of NO2. Therefore, a refined eight-state two-cell SCR-DeNOX model is established in this paper. Meanwhile, the trade-off between NOX emission and tailpipe ammonia (NH3) slip is one of the major challenges which SCR-DeNOX system is facing. While meeting NOX emission standards, the requirement of limiting NH3 slip to prevent secondary pollution is becoming increasingly urgent, which needs a better structure or controller. Therefore, a two-cell SCR-DeNOX system with a by-pass valve in front of the NH3 injection is designed, integral sliding mode control based on inversion algorithm (IA_ISMC) is proposed for each cell. Based on the FTP-75 test cycle, there are three points of view are presented. Firstly, compared with the traditional six-state model, simulation results from the refined eight-state SCR-DeNOX model are closer to the experimental data. Secondly, the introduction of the by-pass structure has a mild impact on the NOX conversion efficiency, but can largely limit the NH3 slip. Finally, the controller based on IA_ISMC effectively improves the tracking performance of NH3 coverage ratio and reduces the cost of NH3 injection. To sum up, the refined two-cell SCR-DeNOX system with a by-pass valve based on IA_ISMC can enhance SCR performance and lower costs.

A Technical Method to Improve NOx/NH3 Mixing Ratio in SCR System and Its Engineering Applications

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

An intelligent control of NH3 injection for optimizing the NOx/NH3 ratio in SCR system

A Partitioned Dynamic Ammonia Injection Strategy Based on Real-Time NOx Flux Distribution Characteristics in an SCR System

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

Optimization of Ammonia Injection Grid in Hybrid Selective Non-Catalyst Reduction and Selective Catalyst Reduction System to Achieve Ultra-Low NOx Emissions

Research on NH3/NOx Mixing in Short and Straight Inlet to SCR Reactor

Optimization and experimental verification of AIG tuning for SCR system of coal-fired power station based on diagnose of flow field

Influence of the Flue Gas Velocity Field at an Ammonia-injectian Grid on Uniform Flow and Reducing-gent Mixing Performance of a High-efficiency SCR (selective Catalytic Reduction) Device

Ammonia injection method for SCR based on non-uniform inlet condition

Coordinated Optimization Control of Flue Gas Temperature for Improving Reaction Efficiency of Catalyst

Anticipatory NH3 injection control for SCR system based on the prediction of the inlet NOx concentration

New optimization method for ammonia/NOx dual control

Study on Optimization Experiment of SCR Denitrification Technologies in a Coal-fired Power Plant

Investigation and Control Technology on Excessive Ammonia-Slipping in Coal-Fired Plants

Influence of Urea-SCR System Parameters on NOx Conversion Rate and Liquid Film

Precise ammonia injection strategy in SCR denitrification system based on non-uniform inlet parameters

Investigating the Optimization Design of Internal Flow Fields Using a Selective Catalytic Reduction Device and Computational Fluid Dynamics

Technical and Economical Analysis of a Novel Rotary Air Preheater System

Ammonia coverage ratio control of a novel two-cell SCR-DeNOX system configuration based on IA-ISMC

Model-based NH3 Adaptation Method for SCR Control