Abstract:Nitrogen oxides (NOxs) are some of the most important hazardous air pollutants from industry. In China, the annual NOx emission in the waste gas of industrial sources is about 8.957 million tons, while power plants remain the largest anthropogenic source of NOx emissions, and the precise control of NOx in power plants is crucial. However, due to inherent issues with measurement and pipelines in coal-fired power plants, there is typically a delay of about three minutes in NOx measurements, bringing mismatch between its control and measurement. Measuring delays in NOx from power plants can lead to excessive ammonia injection or failure to meet environmental standards for NOx emissions. To address the issue of NOx measurement delays, this study introduced a hybrid boosting model suitable for on-site implementation. The model could serve as a feedforward signal in SCR control, compensating for NOx measurement delays and enabling precise ammonia injection for accurate denitrification in power plants. The model combines generation mechanism and data-driven approaches, enhancing its prediction accuracy through the categorization of time-series data into linear, nonlinear, and exogenous regression components. In this study, a time-based method was proposed for analyzing the correlations between variables in denitration systems and NOx concentrations. This study also introduced a new evaluation indicator, part of R2 (PR2), which focused on the prediction effect at turning points. Finally, the proposed model was applied to actual data from a 330 MW power plant, showing excellent predictive accuracy, particularly for one-minute forecasts. For 3 min prediction, compared to predictions made by ARIMA, the R-squared (R2) and PR2 were increased by 3.6% and 30.6%, respectively, and the mean absolute error (MAE) and mean absolute percentage error (MAPE) were decreased by 9.4% and 9.1%, respectively. These results confirmed the accuracy and applicability of the integrated model for on-site implementation as a 3 min advanced prediction soft sensor in power plants.

Anticipatory NH3 injection control for SCR system based on the prediction of the inlet NOx concentration

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Model Predictive Control Case Study: Selective Catalytic Reduction (scr) System in Coal-Fired Power Plant

Prediction and Control of the Nitrogen Oxides Emission for Environmental Protection Goal Based on Data-Driven Model in the SCR De-Nox System

Model-based NH3 Adaptation Method for SCR Control

Enhancement of SCR denitrification control strategy considering fluegas temperature fluctuation: Fundamental principle and performance evaluation

Intelligent ammonia injection control system suitable for full load

Optimization of Ammonia Injection Grid in Hybrid Selective Non-Catalyst Reduction and Selective Catalyst Reduction System to Achieve Ultra-Low NOx Emissions

Predictive control of SCR denitrification system in thermal power plants based on GA‐BP and PSO

Ammonia coverage ratio control of a novel two-cell SCR-DeNOX system configuration based on IA-ISMC

Development of a Real-Time NOx Prediction Soft Sensor Algorithm for Power Plants Based on a Hybrid Boost Integration Model

Investigation and Control Technology on Excessive Ammonia-Slipping in Coal-Fired Plants

Multi‐model predictive control of SCR flue gas denitrification system in coal‐fired power plant based on kernel fuzzy c‐means clustering and integrated model

Dynamic Prediction Model for NOx Emission of SCR System Based on Hybrid Data-driven Algorithms

Coordinated Optimization Control of Flue Gas Temperature for Improving Reaction Efficiency of Catalyst

Model-based urea injection control strategy and ammonia storage estimation for diesel engine SCR system

Prediction and Quantifying Parameter Importance in Simultaneous Anaerobic Sulfide and Nitrate Removal Process Using Artificial Neural Network

Neural Network-Based Prediction of NH3 Leakage from SCR Systems for Diesel Engines

NOx Prediction Model for Multi-coal Admixing Combustion in Boiler

Closed-Loop Control Strategy and State Estimator for Diesel Engine SCR After-Treatment System