A Fast Front-end Readout Design for NICA-MPD Shashlik Electromagnetic Calorimeter
Xinchi Ran,Zhi Deng,Fule Li,Tao Xue,Yi Wang,Qiutong Pan,Lin Jiang,Haoyan Yang
DOI: https://doi.org/10.1109/tns.2024.3486624
IF: 1.703
2024-01-01
IEEE Transactions on Nuclear Science
Abstract:Silicon photomultipliers (SiPMs) are highly valued for their excellent light response and high gain characteristics, yet their application in fast timing scenarios is often limited by their high terminal capacitance, typically over 300 pF. In electromagnetic calorimeters, sub-nanosecond time measurements allow these detectors to function as supplementary time-of-flight devices, specifically aiming for a time resolution of 150 ps in the NICA-MPD. To address these challenges, this study proposes a novel front-end readout electronics design featuring a two-stage common-base transimpedance preamplifier and a 12-bit 200 MS/s pipelined successive-approximation-register (SAR) analog-to-digital converter (ADC). Extensive SPICE simulations, using the Hamamatsu S13360-6025 as the input source, demonstrate the preamplifier’s rapid rise time and good linearity. Experimental results from laser testing confirm that this fast preamplifier design achieves a remarkable time resolution of better than 20 ps. The ADC circuit, designed using the TSMC65nmLP process, employs a two-stage pipelined SAR structure with a two-step conversion technique (6-bit + 7-bit), incorporating redundancy in the second step. Testing at a 160MHz sampling rate with an 80MHz input condition showed that, at Vpk = -1dBFS, the ADC’s FFT spectrum analysis yielded an effective number of bits (ENOB) of 9.34 and a spurious-free dynamic range (SFDR) of 73.8 dBc. Preliminary System-level timing assessments under a 200 MHz sampling rate revealed that waveforms with 3 to 4 sampling points on the rising edge, with a rise time of 15 to 20 ns, achieved a time resolution of approximately 20 ps.