Abstract:The thickening of Ω phase in Al–Cu–Mg alloys containing various bulk Ag contents during stress aging at 200°C with a tensile stress of 240MPa was investigated by a combination of transmission electron microscopy (TEM), high resolution transmission electron microscopy (HRTEM) and atom probe tomography (APT). TEM characterization confirmed preferred orientation of Ω phase in all stress-aged samples. Corresponding quantitative TEM calculations revealed the thickening kinetics of Ω phase was significantly accelerated during stress aging as compared to that during stress-free aging at 200°C. HRTEM analysis on the α/Ω interfacial structure confirmed that the applied tensile stress facilitated the rapid nucleation of the growth ledge on the broad face of Ω phase, thereby resulting in the accelerated plate thickening during stress aging at 200°C. Meanwhile, quantitative TEM analysis highlighted the stress-induced thickening of Ω phase at 200°C was affected by the bulk Ag content. This was consistent with the HRTEM observation as the ledge nucleation was found to be suppressed with increasing Ag addition. Our APT analysis on different stress-aged samples further suggested the progressive enrichment of Ag atoms in the segregation layer helped to stabilize the interfacial structure and was responsible for the lowest nucleation rate of the ledge in 1.77Ag alloy as compared to that in 0.46Ag alloy.

Effect of Ag Additions on the Lengthening Rate of Ω Plates and Formation of Σ Phase in Al-Cu-Mg Alloys During Thermal Exposure

Effects of Ag Variations on the Microstructures and Mechanical Properties of Al–Cu–Mg Alloys at Elevated Temperatures

The Influence of Various Ag Additions on the Nucleation and Thermal Stability of Ω Phase in Al–Cu–Mg Alloys

Effect of Long Time Thermal Exposure on Microstructures of Al-Cu-Mg-Ag Alloy

Effect of Ag content on evaluated-temperature mechanical properties and thermal stability of Al-Cu-Mg-Ag Alloys

Stress-induced Thickening of Ω Phase in Al–Cu–Mg Alloys Containing Various Ag Additions

Effects of Ag Addition on Ageing Precipitation and Microstructure Thermal Stability of an Al-Cu-Mg-Mn Alloy

Microstructure and Mechanical Properties of Al–Cu–Mg–Mn–Zr Alloy with Trace Amounts of Ag

Effects of Thermal Exposure on Mechanical Properties of Al-4.87cu-1.2mg-1.0ag Alloy

Effects of Thermal Exposure on the Mechanical Properties and Microstructure Stability of an Al-Cu-Mg-Ag Alloy

Growth of Ω Plates and Its Effect on Mechanical Properties in Al-Cu-Mg-Ag Alloy with High Content of Silver

Effect of Tensile Stress on Microstructure Evolution of Al-Cu-Mg-Ag Alloys

Effects of Ag Addition on the Microstructure and Thermal Stability of 6156 Alloy

Effect of Ag on Precipitation Behavior of Ω Phase in Al-Cu-Mg Alloy

Effects of Ag Content on Microstructures and Properties of Al-Cu-Mg Alloy

Enhancing the Tensile Strength and Heat Resistance Induced by High-Density Ω Phases in an Al–Cu–Mg–Ag Alloy

Microstructure and Mechanical Properties of Al-Cu-Mg-Ag Alloy During Thermal Exposed at Elevated Temperature

Effects of Ag Addition on Mechanical Properties and Microstructures of Al-8cu-0.5mg Alloy

Study on Thermal Stability of Al-Cu-Mg-Ag-Zr Alloy

Effect of Thermal Exposure on the Microstructure and Properties of Al-Cu-Mg-Ag Alloy