Abstract:In order to better understand the thermal stability and mechanical properties of the nominal Ti–22Al–25Nb alloy with different initial microstructures, microstructural evolution after long-term aging, and mechanical properties at room temperature and 650 °C of four differently heat-treated Ti–22Al–25Nb alloy were investigated. The investigation results indicated that α2 platelets formed by aging at (α2+B2) region were not as stable as previous research claimed and spontaneously decomposed into fine (O+β/B2) mixture during the annealing at 650 °C. As a result, the alloy's steady-state creep strain rate dropped dramatically at the secondary creep stage and tensile strength grew. On the contrary, long time aging exposure resulted in the connection of original dispersed lenticular O precipitation and thus degraded the ductility of all specimens. Besides, the discontinuous precipitation B2→β+O caused by supersaturation of solutes in the matrix also harmed the mechanical properties. Under the condition of 650 °C/250 MPa, the steady-state creep strain rates of the Ti–22Al–25Nb specimens show a significant dependence on their grain size. Crept samples showed that most dislocation motion was restrained in the β channels under a small strain and then extended into O phase when creep strain grew over 10%. Finally, by comparing the room temperature tensile property and creep resistance of four samples, supertransus solution and furnace cooling ensured the alloy most balanced mechanical properties among lamellar samples. The supertransus then furnace-cooled sample did not only have an excellent creep resistance but also kept a moderate room temperature elongation to failure of nearly 6%.

Microstructure and Mechanical Properties of Al-Cu-Mg-Ag Alloy During Thermal Exposed at Elevated Temperature

Influence of thermal exposure on the microstructure evolution and mechanical behaviors of an Al-Cu-Li alloy

Mechanical Properties and Microstructure Evolution of Typical Over-Aging State Al-Zn-Mg-Cu Alloy during Thermal Exposure

Effect of aging route on the precipitation behavior and thermal stability of Al-Cu-Mg-Ag alloy

The Effect of Thermal Exposure on the Microstructures and Mechanical Properties of 2198 Al–Li Alloy

Microstructural Evolution and Tensile Properties of Al-Si Piston Alloys during Long-Term Thermal Exposure

Effect of Thermal Exposure on the Microstructure and Mechanical Properties of 2A97 Al-Li Alloy

Influence of temperature on creep behavior, mechanical properties and microstructural evolution of an Al-Cu-Li alloy during creep age forming

Study on the microscopic mechanism of age-strengthened high damage tolerance Al–Cu–Mg alloys

Microstructure evolution, mechanical properties and tribological behaviors of copper alloy aged at different temperatures

Effects of aging treatment on the precipitation behaviors and mechanical properties of Al-5.0Mg-3.0Zn-1.0Cu cast alloys

Precipitated phase characteristics and fracture behaviour of cast Al–Cu–Mn alloy

Precipitates evolution and strengthening of Al–Mg2Si alloys containing high-Cu contents during ageing process

Effect of ageing and thermal exposure on microstructure and mechanical properties of a HPDC Al–Si–Cu–Mg alloy

Effect of Thermal Exposure on Microstructure Evolution and Mechanical Properties of TC25G Alloy

Effects of Aging Temperature on the Mechanical Properties and Precipitation Behavior of a Pre-strained Al–Cu–Mg–Ag Alloy

High-Temperature Mechanical Behavior of an As-Extruded Al-5Zn-2Mg-0.3Cu (in wt.%) Alloy

Microstructure evolution and mechanical behavior of Cu-7Ni-7Al-4Fe-2Mn alloy via a quenching-aging heat treatment

Thermal stability and mechanical properties of Ti–22Al–25Nb alloy with different initial microstructures

Effect of Aging Treatment on Microstructure and Mechanical Properties of As-Extruded AA6063 Aluminum Alloy

Insight into the aging behavior of a novel Al-Li-Cu-Mg alloy