Abstract:Microstructure formation of a hypo-eutectic Al-11Cu (atom percent) alloy during solidification after laser melting has been studied by transmission electron microscopy (TEM). The evolution of the solid-liquid-interface velocity, VSL, during the solidification process has been determined from direct observation by in-situ TEM. This enabled correlating VSL with development of four distinct microstructure zones. Crystal growth mode transitions from planar to cellular, cellular to dendritic, dendritic to cellular, and cellular to planar, have been observed for the accelerating solid-liquid-interface. The transition from coupled two-phase growth to the single-phase growth occurred for VSL = Va = (0.80±0.05) m/s, where Va is the velocity of absolute stability, at the onset of banded morphology grain formation. The in-situ and post-mortem TEM uniquely permitted determination of the non-equilibrium solidus for the rapidly solidifying Al-11Cu alloy. Experimental evidence for solute clustering and chemical ordering tendencies at length scales on the order of ≤ 5nm has been detected in the single-phase regions of the banded grains. The structural features of the single-phase bands have been interpreted as signatures of 'frozen in' configurations present in the liquid boundary layer adjacent to the growing crystal, which has a width of about 3nm. The nano-scale spatiotemporal resolution experimental TEM studies performed here provided quantitative metrics, e.g. the solidification interface velocity dependent solute concentration of the α-Al phase and the near-atomic scale structure in the single-phase bands, that are uniquely suitable for comparison with theory and model predictions for solidification microstructure development in multicomponent alloys after laser melting.

Interaction between L2 droplets and L1/L interface in solidifying Al–Bi immiscible alloy

In situ analysis of solute and flow fields in directional solidification of immiscible Al–Bi alloy

Dynamic behaviors of minor droplets and the role of bubbles in phase-separating Al Bi immiscible alloy

Effect of Directional Solidification Methods on Solid Solution Window in Ni-based Single-Crystal Superalloy

Simulation of Nucleation and Coalescence of Second Phase Droplets During Earth-Based Solidification Process of Immiscible Alloys

Phase-Field Modeling of Solute Trapping in Single-Phase Alloys During Directional Solidification

Rapid Solidification of Non-Stoichiometric Intermetallic Compounds: Modeling and Experimental Verification

Phase-field simulation of binary alloy during directional solidification

Wettability and Interfacial Heat Transfer During Solidification of Al–Si Alloy (A413) Melt Droplets on Metallic Substrates

Dislocation assisted face-centered-cubic/body-centered-cubic interface mixing during severe plastic deformation

Atomic tuning effect of TiB2 particles on the liquid phase separation behavior of an Al-Bi immiscible alloy

Effect of TiB 2 on the second Bi-rich phase in immiscible Al-Bi alloy

A simple criterion for the selection of interfacial active element to control liquid-liquid decomposition of immiscible alloys

First-principle investigation on the interfacial structure evolution of the δ'/θ'/δ' composite precipitates in Al-Cu-Li alloys

Unraveling L1 2 Al 3 X (X=Ti, Zr, Hf) Nano-Precipitate Evolution in Aluminum Alloys via Multi-scale Diffusion Simulation

Microscopic phase-field study on L12 interface properties of Ni75Al18Cr7 superalloy

Interface velocity dependent solute trapping and phase selection during rapid solidification of laser melted hypo-eutectic Al-11at.%Cu alloy

Nanoparticle Capture During Directional Solidification of Nano-Sized SiC Particle-Reinforced AZ91D Composites

Ab initio molecular dynamics study on the local structures and solid/liquid interface in liquid Al-Ti and Al-B-Ti alloys

Interface interaction during the preparation of TiAl-(Nb, V) quaternary intermetallic single crystals by directional solidification based on Y2O3 doped BaZrO3/Al2O3 composite ceramic mold

The diffusion behaviors at the Cu-Al solid-liquid interface: A molecular dynamics study