Abstract:Quaternary chalcogenide Cu 2 CoSnS 4 (CCTS) thin films were successfully prepared by spray pyrolysis on glass substrates in varying the precursor concentration and the thiourea volume. The effects of the precursor concentration and the thiourea volume on the formation of the CCTS phase were systematically investigated by X-ray diffraction, Raman spectroscopy, Energy-Dispersive X-ray Spectroscopy. The electrical resistivity at room temperature has been measured by the four probes method. It is shown that the crystallization of the stannite CCTS phase depends on both the precursor concentration and thiourea volume. The minimum volume of thiourea required to crystallize the CCTS phase depends on the precursor concentration, i.e. the CCTS crystallization needs higher volume of thiourea at low precursor concentration. For higher precursor concentration, the CCTS is poorly crystallized with the presence of secondary phases such as CuS 2 , CoS 2 , and CuCo 2 S 4 , while the crystallization domain is relatively large. The CCTS well crystallizes only in a narrow range of precursor concentration and thiourea volume. The relatively poor crystallization combined with the presence of secondary phases are harmful for the optical and electrical features of the CCTS film. Besides, optical transmission measurements of the optimized film showed an optical gap of 1.7 eV (~ 730 nm) and an absorption coefficient included between 10 4 and 10 5 cm −1 in the visible solar range. Furthermore, the optimized stannite CCTS films are compact exhibiting a relatively rough and granular surface due to the formation of copper sulfide nodules. The electrical resistivity of the optimized CCTS film is about 0.4 10 –2 Ω cm. These results suggest that the deposited films fit the requirements of absorbing layer in solar cells. The diode composed of Au/Cu 2 CoSnS 4 /SnO 2 films was investigated with current–voltage ( I – V ) measurements performed under dark and bright conditions. The series resistance, saturation current and ideality factor of typical diode is estimated to be 689 Ω, 1.15 10 –5 A and 3, respectively.

The Structural, Morphological and Optical–electrical Characteristic of Cu2XSnS4 (x:Cu,mg) Thin Films Fabricated by Novel Ultrasonic Co-Spray Pyrolysis

Synthesis and Characterization of Hydrazine Solution Processed Cu12Sb4S13 Film

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Structural, optical, electrical, and photovoltaic investigations of p-type Cu2MnSnSe4 thin films as a novel absorber layer for thin film solar cells

Low-cost Fabrication of Cu 2 ZnSnS 4 Thin Films for Solar Cell Absorber Layers

In-depth characterization of physical proprieties of SnS:Mg thin films fabricated by ultrasonic spray for solar cell applications

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Formation of Cu2SnS3 thin film by the heat treatment of electrodeposited SnS–Cu layers

Chemical synthesis of Cu(In) metal inks to prepare CuInS2 thin films and solar cells

[Study of the Physical Properties of SnS Thin Films Deposited by Ultrasonic Spray Pyrolysis Method].

Synthesis of Cu2CoSnS4 chalcogenide thin films by spray pyrolysis and efficient Au/p-CCTS/n-SnO2 diode for cells solar applications

Effect of the stacking order, annealing temperature and atmosphere on crystal phase and optical properties of Cu2SnS3

Structural, optical and magnetic properties of Cu 2 NiSnS 4 thin films deposited by facile one-step electrodeposition

Preparation and properties of Cu2 MgSnS4 thin films and fabrication of heterojunction devices

Band Positions and Photoelectrochemical Properties of Cu2znsns4 Thin Films by the Ultrasonic Spray Pyrolysis Method

Improvement and optimization of Cu2ZnSn(S1-xSex)4 structure for optoelectronic applications

Fabrication of Cu2SnS3 Thin Film Solar Cells Via a Sol-Gel Technique in Air

Substrate and Cu concentration-dependent physical properties of spray-deposited Cu2ZnSnS4 thin films: a comparative study

Preparation And Characterization Of Cu2znsns4 Thin Films And Solar Cells Fabricated From Quaternary Cu-Zn-Sn-S Target

Effects of Cu Doping on the Structure, Electronic and Optical Properties of Sno2 Thin Films by Spray Pyrolysis: an Experimental and Density Functional Study

Study on the Optimization of Cu-Zn-Sn-O to Prepare Cu2ZnSnS4 Thin Film via a Nano Ink Coating Method