Abstract:The physical and optical properties of thin films strongly depend on the film deposition techniques. In this research, Cu 2 ZnSnS 4 (CZTS) thin films were prepared using the sol–gel method and deposited on three kinds of substrates (glass, indium-doped tin oxide (ITO), and fluorine-doped tin oxide (FTO)) by the simple spray pyrolysis method. The influence of the substrate and Cu concentration (0.1 and 0.07 mol/L) on the physical properties of the prepared thin films was examined. The study of X-ray diffraction (XRD) investigation showed that all CZTS thin films possess a single-phase kesterite crystal structure. Field emission scanning electron microscopy (FE-SEM) images showed that the surface of the films was uniform, dense, and had almost no voids, and the particle size of the prepared thin film with the substrate (ITO) was larger than the other samples. The prepared films exhibited an optical band gap ranging from 2 to 2.4 eV. The lowest and highest values of the optical gap correspond to the film with the substrate (ITO) having a lower Cu concentration and the prepared film with the glass substrate having a higher Cu concentration, respectively. The electrical properties and sheet resistance of CZTS thin films were investigated. The best results in terms of electrical properties were related to the ITO substrate with a Cu concentration of 0.1 mol/L. A photoluminescence study showed that the strongest emission peak in the 700–800 nm region was observed for CZTS thin film on ITO substrate. Obtained results indicating the possibility of using the CZTS thin films for efficient and low-cost solar cell and optical applications. Our findings demonstrate that ITO serves as a superior substrate for CZTS fabrication at room temperature. Our results provide an overview of the feasibility of manufacturing optoelectronic devices based on CZTS thin film. Substrate selection is critical in many applications.

Band Positions and Photoelectrochemical Properties of Cu2znsns4 Thin Films by the Ultrasonic Spray Pyrolysis Method

Fabrication and Characterization of Cu2znsns4 Thin Films for Photovoltaic Application by Low-Cost Single Target Sputtering Process

The photovoltaic properties of novel narrow band gap Cu2SnS3 films prepared by a spray pyrolysis method

Investigation of Cu2ZnSnS4 Thin Films with Controllable Cu Composition and Its Influence on Photovoltaic Properties for Solar Cells

Substrate and Cu concentration-dependent physical properties of spray-deposited Cu2ZnSnS4 thin films: a comparative study

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Synthesis and Characterization of Cu 2 ZnSnS 4 from Cu 2 SnS 3 and ZnS Compounds

The Effect of Substrate Temperature, Cu/Sn Ratio and Post-Annealing on the Phase-Change and Properties of Cu2SnS3 Film Deposited by Ultrasonic Spray Pyrolysis

Temperature Dependence of Phonon Modes, Dielectric Functions, and Interband Electronic Transitions in Cu2ZnSnS4 Semiconductor Films

Facile Preparation of Novel Cu–Zn–S Film by Spray Pyrolysis

Photocatalytic H 2 evolution of selective phase CZTS synthesized by ultrasonic spray pyrolysis method

Growth and Characterization of Cu[sub 2]znsns[sub 4] Thin Films by DC Reactive Magnetron Sputtering for Photovoltaic Applications

Preparation And Characterization Of Cu2znsns4 Thin Films And Solar Cells Fabricated From Quaternary Cu-Zn-Sn-S Target

Optical and Electrical Properties Study of Sol-Gel Derived Cu2znsns4 Thin Films for Solar Cells

Preparation and photovoltaic characterization of Cu2ZnSnS4 thin films fabricated by electrodeposition of alloy precursor followed by annealling

Structure, Composition and Optical Properties of Cu2ZnSnS4 Thin Films Deposited by Pulsed Laser Deposition Method

Impact of Sol–gel Precursor Treatment with Preheating Temperature on Properties of Cu2ZnSnS4 Thin Film and Its Photovoltaic Solar Cell

Optical and Electrical Properties of Uniform Non-Toxic Cu2ZnSnS4 Nanocrystal and Its Application in Solar Cells

Cu2znsns4 Thin Film Solar Cells from Coated Nanocrystals Ink

Synthesis and Characterization of Cu2ZnSnS4 Thin Films by the Sulfurization of Co-Electrodeposited Cu–Zn–Sn–S Precursor Layers for Solar Cell Applications

Fabrication of Cu2ZnSnS4 (CZTS) Absorber Films Based on Different Compound Targets