Abstract:1T1R spin-transfer-torque (STT) MRAM is a promising candidate for next-generation high-density embedded non-volatile memory [1-2]. However, 1T1R STT-MRAM suffers from limited sensing margin and high write power. As shown in Fig. 30.2.1(a), sense amplifier design is challenging due to the small difference (only 2x) between the high-resistance state (R AP ) and the low-resistance state (R P ), as well as R AP degradation with increasing temperature. Moreover, R P and R AP resistance distributions shift with process variation, requiring a read reference (V ref ) that tracks process. To improve the sensing margin, several offset-cancellation methods have been reported to reduce sense amplifier mismatch [3]. However, these methods use multiple capacitors and hence incur significant area overheads. To address this issue, we propose an offset-cancelled sense amplifier that uses only a single capacitor to significantly improve the sensing margin by more than 60%. A second design challenge for STT-MRAM stems from the high current needed to flip a cell during a write operation. For non-volatile memory applications with a 10-year retention time requirement, the write current can be as high as several hundred μA. However, as shown in Fig. 30.2.1(b), the required write time varies with the state change required (0→1 or 1→0), process variation, and temperature. As a result, a fixed write time that ensures successful write for all conditions wastes a significant energy for typical or average conditions. We propose an in situ write-self-termination method to reduce write energy in most scenarios. The sense amplifier is reconfigured to continuously monitor the write operation and automatically shuts off the write drivers when the state transition is detected, without an area or timing penalty. In addition, dual dummy columns are added in each array to provide read V ref tracking of row-wise PVT variation. A 1Mb STT-MRAM was fabricated in 28nm technology, and achieves a 2.8ns read-access time at 25°C and 3.6ns at 120°C, respectively. With in-situ self-write-termination the write power is reduced by 47% with a 20ns write-access time at 25°C and by 60% at 120°C.

Read-decoupled 8T1R non-volatile SRAM with dual-mode option and high restore yield

8T1R: A Novel Low-power High-speed RRAM-based Non-volatile SRAM Design.

A symmetric 8T2R NVSRAM with autosave function

A 7T1R Nonvolatile SRAM with High Stability, Low Delay and Low Power Consumption Embedded with Transmission Gates (Tgs)

An 8t/cell FeFET-Based Nonvolatile SRAM with Improved Density and Sub-fJ Backup and Restore Energy

A Highly Reliable and Low-Power Cross-Coupled 18T SRAM Cell

A 1-Mb 28-Nm 1T1MTJ STT-MRAM with Single-Cap Offset-Cancelled Sense Amplifier and in Situ Self-Write-Termination

A Half-Select Disturb-Free 11T SRAM Cell with Built-In Write/Read-Assist Scheme for Ultralow-Voltage Operations

A 1mb 28nm Stt-Mram With 2.8ns Read Access Time At 1.2v Vdd Using Single-Cap Offset-Cancelled Sense Amplifier And In-Situ Self-Write-Termination

A Disturb-Free 10T SRAM Cell with High Read Stability and Write Ability for Ultra-Low Voltage Operations

4.7 A 65nm ReRAM-enabled nonvolatile processor with 6× reduction in restore time and 4× higher clock frequency using adaptive data retention and self-write-termination nonvolatile logic

Highly Area-Efficient Low-Power SRAM Cell with 2 Transistors and 2 Resistors

Energy-Efficient Nonvolatile SRAM Design Based on Resistive Switching Multi-Level Cells.

Nanowire Volatile RAM as an Alternative to SRAM

A 0.2 V-1.8 V 8T SRAM with Bit-interleaving Capability.

Two-Direction In-Memory Computing Based on 10T SRAM With Horizontal and Vertical Decoupled Read Ports

Bit-Interleaving-Enabled 8t Sram with Shared Data-Aware Write and Reference-Based Sense Amplifier

A 28nm 1.5mb Embedded 1T2R RRAM with 14.8 Mb/mm2 Using Sneaking Current Suppression and Compensation Techniques

Charge recycling 8T SRAM design for low voltage robust operation

A Reliable Low Standby Power 10T SRAM Cell With Expanded Static Noise Margins

Column-Selection-Enabled 10T SRAM Utilizing Shared Diff-VDD Write and Dropped-VDD Read for Power Reduction