Abstract:An Li1.3Al0.3SnxTi1.7-x(PO4)3 (LATP-xSn) ceramic solid electrolyte was prepared by Sn doping via a solid phase method. The results showed that adding an Sn dopant with a larger ionic radius in a concentration of x = 0.35 enabled one to equivalently substitute Ti sites in the LATP crystal structure to the maximum extent. The uniform Sn doping could produce a stable LATP structure with small grain size and improved relative density. The lattice distortion induced by Sn doping also modified the transport channels of Li ions, which promoted the increase of ionic conductivity from 5.05 × 10-5 to 4.71 × 10-4 S/cm at room temperature. The SPE/LATP-0.35Sn/SPE composite solid electrolyte with a sandwich structure was prepared by coating, which had a high ionic conductivity of 5.9 × 10-5 S/cm at room temperature, a wide electrochemical window of 4.66 V vs. Li/Li+, and a good lithium-ion migration number of 0.38. The Li||Li symmetric battery test results revealed that the composite solid electrolyte could stably perform for 500 h at 60 °C under the current density of 0.2 mA/cm2, indicating its good interface stability with metallic lithium. Moreover, the analysis of the all-solid-state LiFePO4||SPE/LATP-0.35Sn/SPE||Li battery showed that the composite solid electrolyte had good cycling stability and rate performance. Under the conditions of 60 °C and 0.2 C, stable accumulation up to 200 cycles was achieved at a capacity retention ratio of 90.5% and a coulombic efficiency of about 100% after cycling test.

Facile Modified Synthesis and Intermediate Temperature Electrical Properties of Sn0.95Al0.05P2O7/KSn2(PO4)3 Composite Electrolyte

A stable and easily sintering BaCeO3-based proton-conductive electrolyte

A Novel Sn0.9Ni0.1P2O7/KPO3 Composite Electrolyte with Improved Electrical Properties for Intermediate Temperature Fuel Cells

Synthesis of Sn0.94Sc0.06P2O7 and Its Intermediate Temperature Electrical Properties

Synthesis of Sn0.9Al0.1P2O7−δ/KSn2(PO4)3 Composite Electrolyte Using NaCl/KCl Molten Salt

Intermediate Temperature Electrical Properties of a (na/k)ti2(po4)3/ti0.9mg0.1p2o7 Composite Electrolyte

A novel Ti 0.95 Mg 0.05 P 2 O 7 /(K/Na)Ti 2 (PO 4 ) 3 composite electrolyte with improved electrical properties for ITFCs

A H3PO4-doped Polytetrafluoroethylene/sn0.95mg0.05p2o7 Proton-Conducting Inorganic–organic Composite Electrolyte

Electrochemical Properties of an Sn-Doped LATP Ceramic Electrolyte and Its Derived Sandwich-Structured Composite Solid Electrolyte

Synthesis and Characterization of Proton-conducting Polymer Electrolytes Based on Acrylonitrile-Styrene Sulfonic Acid Copolymer/Layered Double Hydroxides Nanocomposites

Electrochemical Properties of a Co-Doped SrSnO3−δ-Based Semiconductor As an Electrolyte for Solid Oxide Fuel Cells

A Ternary Composite Ti0.95Fe0.05P2O7/NaPO3/NaTi2(PO4)3 Electrolyte with Enhanced Electrochemical Performance for Solid Oxide Fuel Cells

Electrolyte Membranes Based on Molten KH5(PO4)(2) for Intermediate Temperature Fuel Cells

Intermediate Temperature Electrical Properties in 4 Mol% ZnO-doped Zr0.92Y0.08O2-α/NaCl-KCl Composite Electrolyte

Intermediate Temperature Fuel Cell Performance of the Composite Electrolyte Ce0.8Gd0.2O2-α-(Li/K)2CO3

A Novel MgO Doped Zr0.92Y0.08O2-α(8YSZ) with NaCl/KCl Composite Electrolyte for Intermediate Temperature Fuel Cells

Low Temperature Synthesis of Novel SrCe0.9Yb0.1O3−α-chlorides Composite Electrolytes for Intermediate Temperature Protonic Ceramics Fuel Cells

Electrocatalytic Barrier Comprising Polar SnO2 Quantum Dots Anchored Within Porous Carbon Microspheres Prepared by Spray Drying Process for Li–S Batteries

Synthesis, Microstructure and Ionic Conductivity of Li1+xAlxTi2−x(PO4)3-based Composite Ceramic Electrolyte

Room‐Temperature Synthesis of Mesoporous Sn/SnO2 Composite As Anode for Sodium‐Ion Batteries

Enhanced Air and Electrochemical Stability of Li7P3S11–Based Solid Electrolytes Enabled by Aliovalent Substitution of SnO2