Abstract:Nano-sized Ce0.8Gd0.2O2-delta and ce(0.79)Gd(0.2)Cu(0.01)O(2-delta) electrolyte powders were synthesized by the polyvinyl alcohol assisted combustion method, and then characterized by powder characteristics, sintering behaviors and electrical properties. The results demonstrate that the as-synthesized Ce0.8Gd0.2O2-delta and ce(0.79)Gd(0.2)Cu(0.01)O(2-delta) possessed similar powder characteristics, including cubic fluorite crystalline structure, porous foamy morphology and agglomerated secondary particles composed of gas cavities and primary nano crystals. Nevertheless, after ball-milling these two powders exhibited quite different sintering abilities. A significant reduction of about 400 degrees C in densification temperature of ce(0.79)Gd(0.2)Cu(0.01)O(2-delta) was obtained when compared with Ce0.8Gd0.2O2-delta. The ce(0.79)Gd(0.2)Cu(0.01)O(2-delta) pellets sintered at 1000 degrees C and the Ce0.8Gd0.2O2-delta sintered at 1400 degrees C exhibited relative densities of 96.33% and 95.7%, respectively. The sintering of ce(0.79)Gd(0.2)Cu(0.01)O(2-delta) was dominated by the liquid phase process, followed by the evaporation-condensation process, Moreover, ce(0.79)Gd(0.2)Cu(0.01)O(2-delta) shows much higher conductivity of 0.026 S cm(-1) than Ce0.8Gd0.2O2-delta (0.0065 S cm(-1)) at a testing temperature of 600 degrees C. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Intermediate Temperature Fuel Cell Performance of the Composite Electrolyte Ce0.8Gd0.2O2-α-(Li/K)2CO3

A high performance intermediate temperature fuel cell based on a thick oxide–carbonate electrolyte

A stable and easily sintering BaCeO3-based proton-conductive electrolyte

Ce0.8Sm0.2O2-α ceramic prepared by sol-gel method at low temperature and its composite electrolyte in intermediate temperature fuel cells

Low Temperature Synthesize SrCe0.85Er0.15O3－α Using Sol-Gel Method and Its Composite Electrolyte for Intermediate Temperature Fuel Cell

A Novel Gd3+ and Yb3+ Co-Doped Ceria-Sulphate Composite Electrolyte for Intermediate-Temperature Fuel Cells

High-performance Intermediate Temperature Fuel Cells of New SrCe 0.9 Yb 0.1 O 3−α -Inorganic Salt Composite Electrolytes

Intermediate Temperature Electrochemical Properties of Lutetium-Doped SrCeO3/SrZrO3-molten Carbonate Composite Electrolyte

SrCe0.9Sm0.1O3-α Compounded with NaCl-KCl As a Composite Electrolyte for Intermediate Temperature Fuel Cell

Novel Composite Electrolyte of Double-Doped Ceria-Sulphate for Medium Temperature Fuel Cells

Low Temperature Synthesis of SrCe0.9Eu0.1O3-α by Sol-Gel Method and SrCe0.9Eu0.1O3-α-NaCl-KCl Composite Electrolyte for Intermediate Temperature Fuel Cells

Effect of ZnO on the Intermediate-Temperature Electrochemical Properties of Gd0.1Ln0.1Ce0.8O2-α (ln = Er, Yb) for Solid Oxide Membrane Fuel Cells

Composite Electrolyte Based On Nanostructured Ce0.8sm0.2o1.9 (Sdc) For Low-Temperature Solid Oxide Fuel Cells

Preparation and characterization of nanocrystalline Ce0.8Sm0.2O1.9 for low temperature solid oxide fuel cells based on composite electrolyte

Microstructure And Electrical Conductivity Of La0.9sr0.1 Ga0.8mg0.2o2.85-Ce0.8gd0.2o1.9 Composite Electrolytes For Sofcs

Enhanced Electrochemical Properties of Lu-doped BaCeO3 and KCl-NaCl Composite As Electrolyte for Intermediate Temperature Solid Oxide Fuel Cells

Synthesis and Sintering of Gd-Doped Ceo2 Electrolytes with and Without 1 At.% Cuo Dopping for Solid Oxide Fuel Cell Applications

Novel Doped Barium Cerate–carbonate Composite Electrolyte Material for Low Temperature Solid Oxide Fuel Cells

High Performance Gd3+ and Y3+ Co-Doped Ceria-Based Electrolytes for Intermediate Temperature Solid Oxide Fuel Cells

Intermediate Temperature Fuel Cell Durability of Eu-doped SrCeO3-SrZrO3 Solid Solution/ NaCl-KCl Composite Electrolyte

OPTIMIZATION OF SDE-(Li/Na)2CO3 COMPOSITE ELECTROLYTE FOR LOW-TEMPERATURE SOLID OXIDE FUEL CELL APPLICATIONS