Abstract:Boring trepanning association (BTA) deep hole drilling is one of the most important manufacturing techniques to produce a large length-to-diameter ratio hole for industrial applications. In addressing the challenge of excessive surface damage, inefficiency and poor indexing in BTA deep hole drilling, for which there are limited studies reported. The functional behaviour of deep hole machining and the correlation between the machined surface quality, subsurface layer deformation and the machining conditions are investigated in this paper, together with the drilling mechanism. Various parameter combinations are used to produce different samples on which surface roughness and microstructures are studied. Metallurgical characterization is performed on the subsurface regions, followed by qualitative and quantitative mechanical nanohardness investigations. Electron microscopic analysis reveals various surface features such as grooves and plateaus, folding, material flaking that are exclusive to deep hole drilling. It has been found that improved surface integrity in BTA drilling relies on a trade-off among feedrates and speeds. Although considered sample dependent, combination of a feedrate of 28 mm min(-1) and a speed of 630 r min(-1) can produce nearly excellent surface integrity. Grain structure observations over the subsurface reveal three different layered zones including an ultrafine grain structure layer, a transitional grain structure layer and a substrate material layer. A significantly hardened (56% increase) surface layer on cutting-and-burnishing region comparing with the solely cutting region is detected. The subsurface grain features are induced by repeated thermo-mechanical functioning that causes grain refinement and thus materials hardening. The different surface integrities are the result of comprehensive functions of the machining parameters and combined drilling mechanism.

The Improvement of Deep-hole Boring Machining Quality Assisted with Ultrasonic Vibration

A Multiscale Evaluation of the Surface Integrity in Boring Trepanning Association Deep Hole Drilling

Vibration Analysis and Suppression in Robotic Hole Chamfering Process

Ultrasonic vibration–assisted chatter suppression for deep hole boring of stainless steel

Feature Extraction of Chatter for Precision Hole Boring Processing Based on EMD and HHT

Experimental investigation on cavitation effect and surface quality of ultrasonic-assisted micro-hole drilling

Design of Ultrasonic Machining Device for Thin-Wall Cylinder of Air Compressor

New Development of Vibration Drilling Technology——Electric Hot Vibration Drilling

Dynamic chip formation of ultrasonic-assisted micro-drilling on AISI 4340 steel

Experimental Study on Drilling Deep-small Hole by Using Axial Low-frequency Vibration Drilling Technique

Improving Productivity in an Ultrasonic-Assisted Drilling Vertical Machining Center

Effect of ultrasonic assisted EDM based on horizontal vibration on deep and small hole machining

Experimental Research of High-Quality Drilling Based on Ultrasonic Vibration-Assisted Machining

Deep-hole Axis Deviation Mechanism of Weak Stiffness Small-Diameter Single-Lip Tool in Low-Frequency Vibration-Assisted Drilling

Research progress in ultrasonic vibration machining technology

Study on the Simulation and Experiment of Ultrasonic-assisted Vibration Drilling of Ti6Al4V

Research on the Properties of Ultrasonic Vibration Amplitude and Actual Cutting Depth in Rotary Ultrasonic Machining

Theoretical and experimental study on micro ultrasonic-assisted electrochemical drilling with high speed electrode

Experimental research on new hole-making method assisted with asynchronous mixed frequency vibration in TiBw/TC4 composites

Unravelling the influence of vibration on material removal and microstructure evolution in ultrasonic transversal vibration-assisted helical milling of Ti-6Al-4V holes