Enhancement mechanism of electrochemical drilling square-small holes with workpiece vibration
Zhisen Ye,Xiaolei Chen,Guojun Li,Krishna Kumar Saxena,Muhammad Hazak Arshad,Yongjun Zhang
DOI: https://doi.org/10.1016/j.jmapro.2024.01.064
IF: 5.684
2024-02-01
Journal of Manufacturing Processes
Abstract:Square-small holes are used as a critical feature in the fields of aerospace, machine-tooling, automation, and mechanical component construction. Electrochemical drilling (EC-drilling) is a promising approach for manufacturing square-small holes. However, the distribution of flow field in the inter-electrode gap (IEG) becomes non-uniform because of the unique structure of the square-cross-section tubular tool, leading to the accumulation of electrolytic by-products in the IEG. Consequently, both shape accuracy and machining efficiency are reduced. This paper proposes an EC-drilling process with workpiece vibration, in which low-frequency vibration is applied to the workpiece and the size of the frontal IEG is periodically altered. This approach can improve the flow field distribution and eliminate constant low flow velocity zones, resulting in enhanced mass transfer in the IEG. A 3D computational fluid dynamics (CFD) model includes discrete phase was developed to analyze the characteristics of the flow field and elucidate the enhancement mechanism of workpiece vibration in the transfer process. Simulation results revealed that a pulsating electrolyte flow field was produced in both frontal and side IEG induced by workpiece vibration, and that high flow velocity zones were generated alternately in frontal IEG and side IEG. With minimum frontal IEG, there was a high flow velocity in frontal IEG, with parcels (each parcel contains 205 particles) being transported smoothly from frontal IEG to the side IEG. High flow velocity switched to the side IEG when frontal IEG was maximum, and parcels that accumulated in the side IEG were easily removed. With the workpiece vibration process repeated, the parcel transfer process in the IEG was enhanced and the number of parcels accumulating in the IEG significantly reduced. The enhancement of workpiece vibration on the machining of square-small hole was verified by experiments, reflected as enhancement in both the surface quality and shape accuracy of square-small holes. Increasing both the vibration amplitude and frequency enhanced the removal rate of electrolytic by-products, thereby improving machining quality. Machining quality was further improved using a high pulse frequency and low pulse duty cycle. With appropriate parameters, the maximum cathode feed rate reached 1.44 mm/min, 2.4 times that previously reported, and the width and corner radius of the square-small hole was 1.16 mm ± 0.003 mm and 149 μm, respectively, with a surface roughness of 0.54 μm on the sidewall of the square-small hole.
engineering, manufacturing