Abstract:Boring trepanning association (BTA) deep hole drilling is one of the most important manufacturing techniques to produce a large length-to-diameter ratio hole for industrial applications. In addressing the challenge of excessive surface damage, inefficiency and poor indexing in BTA deep hole drilling, for which there are limited studies reported. The functional behaviour of deep hole machining and the correlation between the machined surface quality, subsurface layer deformation and the machining conditions are investigated in this paper, together with the drilling mechanism. Various parameter combinations are used to produce different samples on which surface roughness and microstructures are studied. Metallurgical characterization is performed on the subsurface regions, followed by qualitative and quantitative mechanical nanohardness investigations. Electron microscopic analysis reveals various surface features such as grooves and plateaus, folding, material flaking that are exclusive to deep hole drilling. It has been found that improved surface integrity in BTA drilling relies on a trade-off among feedrates and speeds. Although considered sample dependent, combination of a feedrate of 28 mm min(-1) and a speed of 630 r min(-1) can produce nearly excellent surface integrity. Grain structure observations over the subsurface reveal three different layered zones including an ultrafine grain structure layer, a transitional grain structure layer and a substrate material layer. A significantly hardened (56% increase) surface layer on cutting-and-burnishing region comparing with the solely cutting region is detected. The subsurface grain features are induced by repeated thermo-mechanical functioning that causes grain refinement and thus materials hardening. The different surface integrities are the result of comprehensive functions of the machining parameters and combined drilling mechanism.

Ultrasonic vibration–assisted chatter suppression for deep hole boring of stainless steel

Suppression of Chatter for Precision Hole Boring Based on Variable Structural Stiffness

Magnetorheological fluid-controlled boring bar for chatter suppression

Parameter Optimization of Time-Varying Stiffness Method for Chatter Suppression Based on Magnetorheological Fluid-Controlled Boring Bar

Research on the Boring Chatter Suppression Based on MR Fluid

Feature Extraction of Chatter for Precision Hole Boring Processing Based on EMD and HHT

Chatter Mechanism and Stability Analysis of Robotic Boring

Vibration Analysis and Suppression in Robotic Boring Process

A Multiscale Evaluation of the Surface Integrity in Boring Trepanning Association Deep Hole Drilling

Measurement and Analysis of Dynamic Characteristics of Magnetorheological Intelligent Boring Bar

Early Chatter Identification of Robotic Boring Process Using Measured Force of Dynamometer

Vibration Analysis and Suppression in Robotic Hole Chamfering Process

ICA based separation of chatter symptom signals for precision hole boring processing

Analysis of the Vibration Characteristics of a Boring Bar with a Variable Stiffness Dynamic Vibration Absorber

Finite Element Simulation and Experimental Analysis of Robotic Boring Based on an Approach of Equivalent Stiffness

Chatter suppression by parametric excitation: Model and experiments

Analysis of Cutting Stability of a Composite Variable-Section Boring Bar with a Large Length-to-Diameter Ratio Considering Internal Damping

A Calculation Method for the Stability Lobes of 3-DOF Boring

Cutting Chatter in Ultrasonic Elliptical Vibration Cutting and Its Influence on Surface Roughness and Tool Wear

Study on chatter suppression in ultrasonic-assisted grinding of thin-walled workpiece of SiCp/Al composites

Dynamic chip formation of ultrasonic-assisted micro-drilling on AISI 4340 steel