Vibration Analysis and Suppression in Robotic Hole Chamfering Process

Hui-yue DONG,Qiang SUN,Ying-jie GUO,An-an ZHAO,Wei-dong ZHU

DOI: https://doi.org/10.3785/j.issn.1008-973x.2018.12.001

2018-01-01

Abstract:The vibration causes of robotic hole chamfering were analyzed and a backward machining method was proposed to suppress the vibration. First, the vibration causes were analyzed by building system dynamics model under chamfering cutting force and pressure foot. It is found that the obvious dynamic deformation of robot is produced by axial force and the forced vibration is formed by radial force and tangential force. Furthermore, a backward champing method was proposed to eliminate the effect of axial force on the robot, on the basis of which, the forced vibration was suppressed by choosing reasonable pressure of the pressure foot. Finally, large numbers of forward and backward hole chamfering contrast experiments were conducted; the results verify the reliability of backward machining. The experimental results show that the surface roughness obtained by backward champing is below Ra1.6 μm and the difference of bevel width between the maximum and minimum value is 0.05 mm.