Abstract:Aero-engine nacelle acoustic liners are complex curved surface subassemblies with tens of thousands of dense acoustic holes for noise reduction. Traditional robotic drilling systems with a single spindle and conventional teaching programming cannot meet the high-quality and high-efficiency drilling requirements for nacelle acoustic liners. This paper developed a novel robotic multi-spindle drilling system, which integrates standard industrial robots with a multi-spindle drilling end-effector to drill acoustic holes on an acoustic liner. The task planning strategy and offline programming method are investigated for the robotic multi-spindle drilling of the acoustic liner. A dedicated offline programming software capable of quickly generating robotic machining programs has been designed and developed. A precise acoustic hole arrangement applicable to curved drilling zones is demonstrated. The virtual surrogate hole is introduced to target the array layout of the developed end-effector's multiple spindles. A virtual surrogate hole generation method is proposed based on the minimum mutually exclusive set cover and the greedy algorithm. After that, a virtual surrogate hole layout optimization method is developed using an adaptive genetic annealing algorithm. Then, the frame chain is constructed as the kinematic foundation in robotic multi-spindle drilling of a nacelle acoustic liner. The drilling pose planning of the multi-spindle end-effector based on normal vectors and coordinates of acoustic hole points covered by virtual surrogate holes is explored. And a multi-spindle drilling path planning algorithm is developed using the genetic algorithm. To drill the aero-engine nacelle of a large aircraft, an offline programming software for robotic multi-spindle drilling of the nacelle acoustic liner is developed by integrating the methods above. A case study of multi-spindle drilling task planning of a nacelle acoustic liner is carried out. The case study results indicate that, compared to traditional single-spindle robotic drilling systems, the developed multi-spindle drilling system increases drilling efficiency by approximately 347 %. Using the proposed multi-spindle drilling path optimization algorithm, the drilling path has been shortened by 84.8 %. These results validate the effectiveness of the proposed series of drilling task planning methods and the developed offline programming software, which significantly enhance drilling efficiency while meeting the technical requirements for drilling acoustic holes on the acoustic liner.

Improving Productivity in an Ultrasonic-Assisted Drilling Vertical Machining Center

Drilling Task Planning and Offline Programming of a Robotic Multi-Spindle Drilling System for Aero-Engine Nacelle Acoustic Liners

Ultrasonic assistance in drilling: FEM analysis and experimental approaches

Design of a Novel Air Bearing Workbench for Rotary Ultrasonic Drilling of Advanced Ceramics

Modeling and optimization of thrust force, torque, and surface roughness in ultrasonic-assisted drilling using surface response methodology

Experimental investigation on cavitation effect and surface quality of ultrasonic-assisted micro-hole drilling

Experiments and Finite Element Simulation of Ultrasonic Assisted Drilling

Experimental Research of High-Quality Drilling Based on Ultrasonic Vibration-Assisted Machining

Vibration excitation and energy transfer during ultrasonically assisted drilling

Experiments and simulations on ultrasonically assisted drilling

Design of Ultrasonic Machining Device for Thin-Wall Cylinder of Air Compressor

On the effect of load on vibration amplitude in ultrasonic-assisted drilling

An Experimental Study on Cutting Forces in Ultrasonic Assisted Drilling

Experimental and numerical study of ultrasonically-assisted drilling

Investigation of deviation and surface topography in ultrasonic vibration-assisted milling

Dynamic Analysis on Ultrasonic Vibration Assisted Micro-Drilling of Multi Layered Materials Using ABAQUS Explicit

Ultrasonic-assisted drilling of Inconel 738-LC

Study on modal analysis and chip breaking mechanism of Inconel 718 by ultrasonic vibration-assisted drilling

Technological efficiency of introducing the energy of the ultrasonic field in the area of processing holes in complex packages of composite materials and titanium alloys

Machining forces in ultrasonic-vibration assisted end milling

Dynamic chip formation of ultrasonic-assisted micro-drilling on AISI 4340 steel