Abstract:This paper presents a novel general single/multi-parameter optimization model for the thermoelectric cooler (TEC) based on the 1D resistance method, which precisely captures all the thermoelectrical effects and the impacts of temperature-dependent thermoelectric properties, thermal operating conditions, and contact resistance at the solder layer, respectively. The explicit analytical expressions of designed optimal parameters, including the applied current, thermoelectric leg length, the cross-section area ratio of P/N-type thermoelectrical legs, and the number of leg pairs, are derived to maximize TEC performances (such as cooling capacity, coefficient of performance, or temperature difference between the cold/hot sides) under different operating conditions. The validation of the developed model is conducted through comparisons with the reported experimental data or 3D simulation results. The inherent correlations between the designed parameters are demonstrated and used to clarify the conflicting results in the literature. The ratio of leg length and its area cannot be assumed as an independent optimal parameter for large contact resistance. The filling ratio of thermoelectrical legs should be chosen as large as possible and limited by the manufacturing technology. It is demonstrated that the multiplication of applied current and number of leg pairs could be considered an independent optimal parameter, which provides a new strategy to design the available applied current for practical applications. The correlation between applied current and leg length is also discussed in detail. Multi-parameter optimization could remarkably improve the TEC performance compared with the single-parameter model, such as a significant improvement by 31% for the optimal cooling capacity. The cooling capacity is enhanced by 98% when the convective heat transfer coefficient of 1000 W/m(2)K at the cold/hot sides increases to 2000 W/m(2)K. A decrease of 15% for cooling capacity induced by the contact resistance is also observed. The present work provides a promising comprehensive tool for intensifying TEC performance maximization and clarifying its impact factors and the multiparameter inherent correlation.

Numerical Modeling of the Thermoelectric Cooler with a Complementary Equation for Heat Circulation in Air Gaps

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered

Transient Modeling and Dynamic Characteristics of Thermoelectric Cooler

Design and Optimization of Thermoelectric Cooling System under Natural Convection Condition

Theoretical Analysis of the Cooling Performance of a Thermoelectric Element with Temperature-Dependent Material Properties

Irreversibility of thermoelectric cooling model: Newtonian linear heat transfer and finite time thermodynamics

Study on the Performance of Thermoelectric Refrigerator under Natural Convection Heat Transfer Condition

Numerical Simulation of the Thermoelectric Model on Vehicle Turbocharged Diesel Engine Intercooler

Performance Analysis and Assessment of Thermoelectric Micro Cooler for Electronic Devices

Two-dimensional Electrical Modeling of Thermoelectric Devices Considering Temperature-Dependent Parameters under the Condition of Nonuniform Substrate Temperature Distribution

An Effective Method of Evaluating the Device-Level Thermophysical Properties and Performance of Micro-Thermoelectric Coolers

Assessment and validation of a numerical model for phase change materials heatsink on thermoelectric devices

Multi-parameters Analysis and Optimization of a Typical Thermoelectric Cooler Based on the Dimensional Analysis and Experimental Validation

Numerical Study and Optimization of a Combined Thermoelectric Assisted Indirect Evaporative Cooling System

Thermal Resistance Matching for Thermoelectric Cooling Systems

Numerical Simulation of a Thermosyphon Radiator Used in Electronic Devices

Modeling and Analysis of the Influence of Thomson Effect on Micro-Thermoelectric Coolers Considering Interfacial and Size Effects

Analytical Model-Based Optimization of the Thermoelectric Cooler with Temperature-Dependent Materials under Different Operating Conditions

Performance and regression analysis of air-cooled thermoelectric cooling system using response surface methodology and numerical simulation