Abstract:Homogenously doped and mixed yttria stabilized zirconia, YSZ (with 3 and 10mol% Y2O3 known as 3YSZ and 10YSZ) and NiO/10YSZ co-precipitates (nominally corresponding to 7, 12, 24, 30, 35 and 45vol.% Ni metal), were synthesized using a continuous hydrothermal flow synthesis (CHFS) system which uses a stream of superheated water at 450°C and 24.1MPa as a reaction medium to cause rapid precipitation of metal oxide nanoparticle co-precipitates from a mixed metal salt solution. All products were obtained directly from the outlet of the CHFS reactor as a slurry, which was then cleaned and freeze-dried prior to further processing. The highly crystalline nano-powdered products were characterized using a range of analytical methods, including: powder X-ray diffraction (XRD), energy dispersive spectroscopy (EDS), transmission electron microscopy (TEM), Raman spectroscopy and BET surface area measurements. Spherical primary particles of 10YSZ and 3YSZ were observed under the TEM and found to be 5.0±0.8nm (range 3.2–6.3nm) and 6.2±1.4nm (range 3.3–8.4nm) in size, with measured BET surface areas of 160.6 and 241.7m2g−1, respectively. Sintering of the nano-powder co-precipitates was performed via spark plasma sintering (SPS) at 1100°C for 1min, leading to densities of ca. 98% for 10YSZ and ca. 96% for Ni/10YSZ cermets (all NiO was converted into Ni due to the reducing atmosphere of the SPS). The 24% Ni/10YSZ cermet was subjected to focused ion beam tomography, which allowed the 3D arrangement of the conducting Ni metallic network of the dense cermet to be elucidated, and showed that a complete 3D network of Ni existed throughout the dense cermet disk. Electrical conductivity tests showed that the samples exhibited higher than expected electrical conductivity (for such low metal content), e.g., the 24vol.% Ni-containing sample achieved an electrical conductivity of ∼200Scm−1 at the fuel cell operating temperature, which corresponds to an effective conductivity of ∼117Scm−1 if a porosity of 30% were to be introduced.

Synthesis of Doped Ceria–zirconia Core–shell Nanocomposites Via Sol–gel Process

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

A General Propylene Epoxide-assisted Sol-Gel Route for the Synthesis of ZrO2-SnO2 Composite Sols

Highly conductive low nickel content nano-composite dense cermets from nano-powders made via a continuous hydrothermal synthesis route

Synthesis of Monolithic Zirconia with Macroporous Bicontinuous Structure Via Epoxide-Driven Sol–gel Process Accompanied by Phase Separation

Scalable synthesis of multicomponent multifunctional inorganic core@mesoporous silica shell nanocomposites

Preparation of GDC Nanopowders and GDC/YSZ Core-Shell Nanocomposites

Preparation and Characterization of Ceria-Zirconia Ceramics Using a Sol-Gel Process

Synthesis of ZrB2-SiC-ZrC Composite Powders with Core-Shell Structure Via Sol-Gel Molecular Modulation

Rational design and synthesis of cerium dioxide-based nanocomposites

Nano-dispersed yttria-stabilized zirconia powder: Phase, morphology, and conductivity investigation with different chelating agents via a modified sol-gel method

Nanocomposite Ysz-Ni Based Cermet Powders Synthesized by Complexes-Gel-Conversion Process

NANO-SCALE Sm0.15Gd0.05Ce0.8O1.9POWDER PREPARED BY COUPLING ROUTES OF SOL-GEL AND LOW TEMPERATURE SELF-PROPAGATING COMBUSTION

Synthesis and Characterization of ZSM-5/amorphous Silica Composite Materials

General and facile synthesis of ceria-based solid solution nanocrystals and their catalytic properties

Cold sintering of ceria-based solid electrolyte with the assistance of a core-shell structure

Synthesis and microstructure of La-doped ceria nanoparticles.

Synthesis of 1Y6Ce-ZrO2 nanoparticles with excellent sintering performance via novel Sol-Gel-Flux method

Effects of Synthetic Parameters in Pechini Method on the Formation and Properties of (zro2)0.92(sc2o3)0.08 Solid Solution

Electrochemical Study on Co-Doped Ceria–carbonate Composite Electrolyte

Fabrication, Microstructural Evolution, and Mechanical Properties of SiC/(Hf0.25Ta0.25Zr0.25Nb0.25)C/C Nanocomposites