Abstract:In this work, based on the sol-gel method combined with spray granulation technology, a novel process method to prepare Yttria stabilized ZrO2 beads with 5–50 µm diameter, 123 nm grains size, few pores, solid internal structure and well spherical type is proposed. These advantages can greatly improve the beads density, and decline the sintering temperature. The optimum preparation parameters, including sol and spray parameters, baking and sintering conditions, are obtained through the investigation of experimental conditions. The SEM test results of the surface and cross section morphologies show that the beads have solid structure and there is good consistency between the surface and interior of the beads. The average grain size of test results is about 123 nm. The XRD test results demonstrate that no monoclinic phase exists in the beads. The sintering temperature of the new process is only 1200 °C. In this work, based on the sol-gel method combined with spray granulation technology, a novel process method to prepare Yttria stabilized ZrO2 beads with 5–50 µm diameter, 123 nm grains size, few pores, solid internal structure and well spherical type is proposed. These advantages can greatly improve the beads density, and decline the sintering temperature. The processes of the method mainly contain: sol preparation, spray forming process, organic compound discharging and sintering. The optimum preparation parameters, including sol and spray parameters, baking and sintering conditions, are obtained through the investigation of experimental conditions. The tested density result of the prepared beads is about 6.024 g/cm3 which is higher than for the traditional process. The SEM test results show that the diameter of the prepared Yttria stabilized ZrO2 beads is range from 5 to 50 µm with good sphericity. The surface and cross section morphologies show that the beads have solid structure and there is good consistency between the surface and interior of the beads. The average grain size is about 123 nm, no pores between grains. The XRD test results demonstrate that no monoclinic phase exists in the beads. The sintering temperature of the new process is only 1200 °C.

Synthesis of 1Y6Ce-ZrO2 nanoparticles with excellent sintering performance via novel Sol-Gel-Flux method

CeO2-stabilised ZrO2 Nanoparticles with Excellent Sintering Performances Synthesized by Sol-Gel-flux Method

5Y–ZrO2 NPs with high dispersity and excellent sintering performance prepared by a novel sol-gel-flux method in the NaCl system

Synthesis, Characterization and Application of Submicron ZrSiO4 Powder Via Sol-Gel-microemulsion-hydrothermal Method

Sintering Properties of Tetragonal Zirconia Nanopowder Preparation of the NaCl + KCl Binary System by the Sol–Gel–Flux Method

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

Preparation and Properties of CaTiO_3:Zn Nanoparticles Based on Sol-Gel Method

Sintering kinetics of cerium-stabilised tetragonal zirconia

Realizing near-full density monophasic tetragonal 1.5-mol% yttria-stabilized zirconia ceramics via current-ramp flash sintering

Preparation of Gd2Zr2O7 nanopowders by polyacrylamide gel method and their sintering behaviors

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

Sol-gel preparation of ZrO2–Li2Si2O5 ceramics and their sintering properties

Ce-Substituted Nanograin Na3Zr2Si2PO12 Prepared by LF-FSP as Sodium-Ion Conductors

Synthesis of Nanocrystalline Ce<sub>0.8</sub>Sm<sub>0.2</sub>O<sub>1.9</sub> by Citrate Gel Method

Synthesis and Characterization of Nanoscaled Cerium (IV) Oxide Via a Solid‐State Mechanochemical Method

Synthesis of nanocrystalline Ce0.8Sm0.2O 1.9 by citrate gel method

Synthesis of the superfine high-entropy zirconate nanopowders by polymerized complex method

Synthesis of Nanocrystalline Ce0.8sm0.2o1.9 by Citrate Gel Method

Stronger and Tougher Nanosized Dense Ceria-Doped Tetragonal Zirconia Polycrystals by Sinter-Hip

Preparation and Characterization of Multielement Composite Oxide Nanomaterials Containing Ce, Zr, Y, and Yb via Continuous Hydrothermal Flow Synthesis

Novel process of preparation of Yttria stabilized ZrO2 small sizes beads using sol-gel method combined with spray granulation technology