Abstract:The double-wall, bimetallic CRA-lined pipe has an inner layer made of a very resistant CRA and an outer layer made of low-cost carbon steel providing the line pipe with the required strength and toughness, which has been widely applied in oil production, nuclear power plants and refining industry. Clad pipe can be manufactured by various techniques that include hot coextrusion, hot-rolled bonding, explosive bonding, centrifugal casting and hydraulic expansion of a CRA pipe inside and a carbon-steel outer pipe. Compared with kinds of methods, hydraulic expansion process is easy to control, clad pipe can be economically manufactured and its quality is better, so it is deserved to develop. This paper mainly presents the clad pipe, which inner pipe is stainless steel and outer pipe is carbon steel to be formed by hydraulic expansion process. According to the basic supposition,the material and mechanics models of inner pipe and outer pipe have been established. (1) The material of the inner piper is considered as linear hardening behavior, and the outer pipe is described as ideally plastic material since its plastic deformation is smaller. (2) During the hydraulic expansion, the axial force in pipes can be neglected according to our experimental model, so the stress on pipes can be got by simplified as problem of planar stress. The main principle of hydraulic expansion process for clad pipe has been described. Adopting the elasticity-plasticity theory, the stress and strain during loading and the residual stress and strain after unloading for the inner and outer pipe of clad pipe have been discussed. By using the distortion matching condition the calculating formulas related hydro-forming pressure to the residual contact pressure between has been derived. The range of expansion pressure is got according to the different demands for residual contact pressure of clad pipe, and the maximum and minimum value of hydro-forming pressure is given. In order to obtain the residual contact pressure, the yield stress of outer pipe must be more than inner pipe or it's hardening stress. The theoretical analysis is verified by experimental results.

CALCULATION OF HYDRO-FORMING PRESSURE FOR BI-METAL CLAD PIPE

Study on Hydro-Forming Technology of Manufacturing Bimetallic CRA-lined Pipe

Theoretical Study on Thermal Hydraulic Expansion Process of Stainless Steel Lined Clad Pipe

Theoretical and Experimental Study of Bimetal-Pipe Hydroforming

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

The Hydroforming Process with Radial Self-energizing Seal for Manufacturing Bimetal-lined Pipe

Elastic Buckling of Cylindrical Pipe Linings with Variable Thickness Encased in Rigid Host Pipes

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

Surface Stress Analysis of Internally Corroded Pipes under External Pressure

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Analysis of Steel Strip Flexible Pipes under Internal Pressure and Bending

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Finite Element Analysis on the Mechanical Properties of the Combined Fittings With a Long Radius and Double Elbows

Experimental Investigation on Double-Layered Pipe During Hydro-Expanding

Numerical Simulation and Experimental Confirmation of a Bimetallic Pipe Forming Process

Theoretical Analysis and Numerical Simulation on the Hydraulic Expansion of Double-Layered Tubes

Stress Analysis and Evaluation of Special Shape Pressure Pipe