Abstract:A new theoretical model was proposed to calculate the burst pressure of steel strip reinforced flexible composite pipes (steel strip PSP) based on the thin wall cylindrical shell theory and the squeeze pressure expression between layers was derived. The radial displacement discontinuity of pipe wall in pipe-end fitting joint area takes in account in this model which could result in Stress Concentration Effect (SCE) in reinforcement layers. The SCE is caused by swaging end fitting clamped tightly at the end of the pipe. The result of the hoop strain in the joint area calculated by this model is greater than the one calculated by the classic elastic model, which leads to relative conservative burst strength of the pipe. The hoop stress variation via internal pressure on innermost reinforcement layer is introduced to predict the burst strength of the pipe. As the stress in the joint area reaches its ultimate strength, the strain on the same layer in the point far away from this area (x?8) is extracted and the corresponding internal pressure is obtained as the burst strength of the pipe. The calculated data from two models were compared with the experiment results and the proposed new model showed better accuracy than the classic elastic model. Final additional parametric studies were conducted, while the effect of the pipe diameter, the winding angle, the number and thickness of the reinforcement layer on the burst strength of the pipe were studied. Useful conclusions were drawn for the design and application of the steel strip PSP in offshore engineering.

Analysis of Steel Strip Flexible Pipes under Internal Pressure and Bending

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Prediction Of Internal Pressure Of Flexible Pipe

Behavior of Flexible Pipe Subjected to Internal Pressure

Theoretical Modeling Of Steel Strip Reinforced Flexible Pipe With Swaging End Fitting By Taking Into Account Stress Concentration Effect

On the Collapse Failure of Dented Pipes under Bending Moment and External Pressure

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Mechanical Behaviors Of Steel Strip Reinforced Flexible Pipes Under Bending

Failure Behavior Analysis of Steel Strip–reinforced Flexible Pipe under Combined Tension and Internal Pressure

On the analysis of burst capacity of steel strip reinforced flexible pipe with swaging endfitting

Mechanical Responses of Metallic Strip Flexible Pipe Subjected to Combined Bending and External Pressure

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

ANALYSIS OF FIBRE GLASS REINFORCED FLEXIBLE PIPES UNDER INTERNAL PRESSURE

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Mechanical study on overbend segment of submarine pipeline during S-Lay

Behaviour of steel wire-reinforced thermoplastic pipe under combined bending and internal pressure

An analytical approach for assessing the collapse strength of an unbonded flexible pipe

Analysis of steel strip reinforced thermoplastic pipe under internal pressure

Buckling Response of Offshore Pipelines under Combined Tension, Bending, and External Pressure

Buckle Propagation Analysis of Deep-Water Petroleum Transmission Pipelines with Axial Tension