Abstract:This paper presents a high quality-factor (Q-factor) quartz tuning fork (QTF) with a glass probe attached, used in frequency modulation tapping mode atomic force microscopy (AFM) for the surface profile metrology of micro and nanostructures. Unlike conventionally used QTFs, which have tungsten or platinum probes for tapping mode AFM, and suffer from a low Q-factor influenced by the relatively large mass of the probe, the glass probe, which has a lower density, increases the Q-factor of the QTF probe unit allowing it to obtain better measurement sensitivity. In addition, the process of attaching the probe to the QTF with epoxy resin, which is necessary for tapping mode AFM, is also optimized to further improve the Q-factor of the QTF glass probe. The Q-factor of the optimized QTF glass probe unit is demonstrated to be very close to that of a bare QTF without a probe attached. To verify the effectiveness and tire advantages of the optimized QTF glass probe unit, the probe unit is integrated into a home-built tapping mode AFM for conducting surface profile measurements of micro and nanostructures. A blazed grating with fine tool marks of 100nm, a microprism sheet with a vertical amplitude of 25 mu m and a Fresnel lens with a steep slope of 90 degrees are used as measurement specimens. From the measurement results, it is demonstrated that the optimized QTF glass probe unit can achieve higher sensitivity as well as better stability than conventional probes in the measurement of micro and nanostructures.

Experimental Measurement of the Nanoscale Vibration of Microprobe

Vibration Compensating Beam Scanning Interferometer for Surface Measurement

Theoretical Analysis and Experimental Study on the Characteristics of Microprobe Vibration

High Quality-Factor Quartz Tuning Fork Glass Probe Used In Tapping Mode Atomic Force Microscopy For Surface Profile Measurement

Characterization of Nanoscale Vibration Using Tapping Mode AFM

T0301-2-5 Modifying the Structure of Microwave AFM Probe for Improving the Sensitivity in the Measurement of Electrical Properties

Study of the Raman-Afm System for Simultaneous Measurements of Raman Spectrum and Micro/Nano-Structures

Out-of-plane Vibration Measuring Technique Based on Dynamic AFM

Enhancement of Sensitivity for the Evaluation of Electrical Properties by Modifying the Nano Structure of Microwave Afm Probe

Micro-vibration measuring technology based on heterodyne interference

Research On The Sensing Performance Of The Tuning Fork-Probe As A Micro Interaction Sensor

Dimension Measurement Based on MEMS Micro Tactile Probe and Nanomeasuring Machine

Applications of Laser Vibrometer in Vibration Measurement of Microstructures

Sensing Performance Analysis on Quartz Tuning Fork-Probe at the High Order Vibration Mode for Multi-Frequency Scanning Probe Microscopy.

Probe-Type Microforce Sensor for Mirco/Nano Experimental Mechanics

Experimental Study Of Vibration Measurement Based On Laser Frequency Splitting Principle

High-speed and high-precision measurement of biaxial in-plane displacements: tens of nanometers principle error suppression in microprobe sensors

Scanning test platform based on MEMS micro tactile probe and nanomeasuring machine

Three-Dimensional Nano Measurement System Based on Resonant Trigger Probe

Fabrication and testing of a novel silicon probe for micromachined surface profilers.

Probe Experimental Mechanics