Abstract:Using the shear-compression specimen (SCS), thermo-viscoplastic behavior of DP800 steel has been investigated systematically over a wide range of strain rates, including quasi-static (0.001-1 s(-1)), intermediate (10-100 s(-1)), high (2000-8000 s(-1)) and ultra-high (16,000-50,000 s(-1)) regions. Temperatures between 293 and 1073 K were considered. Experimental results show: (1) DP800 steel exhibits non-linear strain rate sensitivity. For tests at strain rates lower than 4000 s(-1), the flow stress increases slightly. However, for tests at strain rates above 8000 s(-1), a significant flow stress upturn exists; (2) dynamic strain aging (DSA) occurs within the temperature range of 473-873 K and strain rates below 100 s(-1); (3) both strain rate sensitivity and temperature sensitivity of DP800 steel are influenced by DSA, and bell-shaped sensitivity curves form; (4) with increasing strain rates, peaks of the bell-shaped temperature sensitivity curves move to higher temperature regions, and this law is equally valid for the effect of temperature on the strain rate sensitivity curves; (5) strain hardening behavior of DP800 steel is dominated by a competition between strain rate hardening, DSA hardening and thermal softening. With increasing strain rate, single peak or double peaks are observed in average strain hardening rate-strain rate curves. According to experiments, a semi-physical constitutive relation has been established, taking into account both the viscous drag effect and the DSA phenomenon. The established constitutive model can predict flow stress curves of DP800 steel accurately with an average error of 7.12%. Both the enhanced strain rate sensitivity due to viscous drag and the bell-shaped flow stress curves caused by DSA are captured correctly.

Mechanical Behavior of a Stainless Steel Material at Elevated Temperatures and High Strain Rates

Mechanical behavior of stainless steel Cr12Mn5Ni4Mo3Al at high temperature and strain rate

Effect of High Temperature Exposure and Strain Rate on Mechanical Properties of High-Strength Steel Rebars

DYNAMIC MECHANICAL PROPERTIES OF STAINLESS STEEL 0cr18ni10ti WELDED JOINT AT ELEVATED TEMPERATURES AND HIGH STRAIN RATES

Plastic Behavior and Constitutive Relations of DH-36 Steel over a Wide Spectrum of Strain Rates and Temperatures under Tension

Validity analysis of materials' dynamic tensile SHTB experimental technique at ultrahigh temperature

Dynamic tensile properties of a single crystal Nickel-base superalloy at high temperatures measured with an improved SHTB technique

Dynamic Compressive Behavior of a Single Crystal Nickel-Base Superalloy at Ultra-High Temperature: Mechanism Investigation with a Modified Electric Synchronous SHPB Technique

Dynamic strain aging characteristics in DH36 steel

Effect of High Temperature and High Strain Rate Coupling on the Property of Single-crystal Nickel-base Superalloy DD407

A New Method of Tensile Performance Testing for Materials at High Temperature and High Strain Rate

Stress–strain curves for stainless steel at elevated temperatures

Deterioration of Mechanical Properties of Novel Constructional Steel Material at Elevated Temperatures

Dynamic Mechanical Properties and Constitutive Relationship of Hardened Steel (45HRC) under High Temperature and High Strain Rate

Dynamic behavior of SUS304 stainless steel at elevated temperatures

Dynamic Mechanical Behavior at Elevated Temperatures and High Strain Rates of Low Yield Point Steels

A critical assessment of high-temperature dynamic mechanical testing of metals

Experimental Research on Dynamic Mechanical Behavior of TC18 Titanium Alloy under Medium and High Strain Rates

Effect of High Temperature and High Strain Rate on the Dynamic Mechanical Properties of Fe-30Mn-3Si-4Al TWIP Steel

Constitutive Equations to High Temperature Flow Stress of 0Cr11Ni2MoVNb Stainless Steel

Thermo-viscoplastic Behavior of DP800 Steel at Quasi-Static, Intermediate, High and Ultra-High Strain Rates