Abstract:Summary form only given. Recently, the state-of-the-art of lithium-niobate-on-insulator (LNOI) has been reviewed [1]. In analogy to silicon-on-insulator (SOI), the new material platform for integrated optics with wafers of up to 3” diameter enables the fabrication of optical waveguides with small cross-sections and small bending radii due to the high refractive index contrast. As a consequence, ultra-compact photonic integrated devices such as ring resonators and photonic crystal structures have been developed.Here we demonstrate also Er-doped LNOI, which might become an ideal material for nano-optical amplifiers and lasers. Doping is achieved by pre-diffusion of Er into the upper LN wafer before bonding [2], and the resulting Er concentration is about 1020 cm-3. Ridges of different width w = (2.5 - 10) μm were fabricated on these LNOI substrates (LN thickness of 960 nm) using precision diamond-blade dicing which results in smooth side walls of the fabricated waveguides. We present results of a first investigation of the erbium centers using Raman and fluorescence spectroscopy of planar and ridge waveguides in Er:LNOI.Characterization of the waveguides was performed using Raman and fluorescence spectroscopy. Spectral scans were obtained using a scanning confocal microscope and a 488 nm laser. Besides line broadening that may be attributed to internal strain in the bonded layer, analysis of the Raman spectrum shows no significant difference between the waveguide and the bulk material. However, the erbium emission of the 4H15/2 and 4S3/2 to the 4I15/2 contains several differences in the intensity ratios indicating that the relative transition probabilities are different for the smart cut waveguide. While Raman intensity has a linear relationship with pump power, the intensity of the Er emission starts saturating at pump levels of only a few mW. To investigate fluorescence of the 4I13/2 - 4I15/2 transition inside the formed ridges, a fiber coupled lase- with a wavelength of 980 nm is used for pumping. The rhs of the figure above shows a diced ridge and the green fluorescence that can be observed when the ridge is pumped at 980 nm. An example of the IR fluorescence is given on the right of the above figure using 40 mW of pump light, with the spectrum of an erbium doped fiber as a reference. The emission is broadened and maxima are shifted to longer wavelengths, which may be attributed to defects induced by implantation, re-absorption of fluorescence light, and contributions by amplified spontaneous emission due to the waveguiding effect.

Formation of Color Centers of Optical Waveguide in LN Crystal by Implanting It with 3 MeV Oxygen Ions

Formation of Optical Waveguide and Annealing Behaviour of LiNbO 3 Implanted by 3.0-Mev Nickel Ions

Annealing Effect on Planar Waveguides in LiNbO3 Produced by Oxygen Ion Implantation

MgO:LiNbO3 Planar Waveguide Formed by MeV O2+ Implantation and Its Annealing Characteristics

Low-Dose Ion Implanted Active Waveguides in Nd3+ Doped Near-Stoichiometric Lithium Niobate: Promising Candidates for Near Infrared Integrated Laser

Near-infrared single-mode optical waveguide fabrication in LiF crystal by carbon ion irradiation

Optical Damage of Zr:LiNbO3 Waveguides Produced by Proton Implantation

Three-dimensional Numerical Simulation on the Directly Written Waveguide Formation with 320 Nm UV Laser in Lithium Niobate

MeV Ti ion-implantation-induced damages in LiNbO3

Formation of optical waveguides in KNbO3 by MeV boron ion implantation

Optimum Exposure Intervals for Light-Induced Optical Waveguides in Lithium Niobate Crystals by Laser Micromachining

Planar waveguides in neodymium-doped calcium niobium gallium garnet crystals produced by proton implantation

3d imprinting of Voxel‐Level Structural Colors in Lithium Niobate Crystal

Optical and Structural investigations of LiNbO3 thin films by PLD

Planar Optical Waveguides In Knbo3 Formed By Mev B And He Ion Implantation

Analysis of Optical Waveguide Formation in Er:NaY(WO4)2 Crystal by MeV He+ Ion Implantation

Fluorescence in planar and ridge waveguides fabricated in Erbium-Doped lithium-niobate-on-insulator (Er:LNOI)

Formation Enthalpy Calculation of Oxygen Vacancy Defect in Doped Lithium Niobate Crystals

Photoluminescence from Optical Waveguiding Linbo3 Film Formed on Crystalline Sio2 Substrate by Pulsed Laser Deposition

Preparation and characteristics of the O3+-ion-implanted and femtosecond laser-ablated waveguide in the high-gain Nd3+-doped laser glass

Pulsed laser deposition of c-orientedLiNbO3LiTaO3 optical waveguiding bilayered films on silicon wafers