Abstract:The introduction of aliphatic structure by co‐carbonization of coal tar pitch and atmospheric residual provides more methylene bridge bonds and more α‐hydrogens for spinnable pitch, which makes pitch molecular more linear and naphthenic. The α‐hydrogens of aliphatic structure of the CCA‐3 are easily attacked by oxygen, showing a higher oxidative stabilization efficiency. The obtained pitch‐based carbon fiber shows excellent mechanical properties. As a pivotal step in the preparation of carbon fiber, oxidative stabilization not only plays a crucial role in maintaining fibrous morphology but also contributes significantly to enhance mechanical properties of resultant carbon fiber. Due to high activation energy of pitch molecules reaction with oxygen and the sluggish diffusion of oxygen within the fiber, the improvement of oxidative stabilization efficiency faces significant challenges. Atmospheric residual (AR) has a high and easily oxidized aliphatic structure. Spinnable pitch is synthesized by co‐carbonization of coal tar pitch (CTP) and AR at a ratio of 3:1 in this work. Its methylene bridge bond ratio is 4.45% and have an appropriate amount aliphatic structure, which makes pitch molecular more linear and naphthenic. Excessive addition of AR is detrimental to spinning performance. The most optimal oxidative stabilization temperature of as‐spun fiber was 280°C, which is lower than that of fiber produced by CTP alone (300°C), displaying a higher oxidative stabilization efficiency. The obtained pitch‐based carbon fiber shows excellent mechanical properties with tensile strength of 999.0 ± 80.1 MPa and Young's modulus of 57.7 ± 3.5 GPa. The co‐carbonization by two different substances has been applied in manufacturing carbon fiber, providing a facile approach to accelerate the oxidative stabilization of pitch fiber.

Fabrication and oxidation behavior of pitch-based C/C composites

Improving carbon/carbon composites mechanical and thermal properties by the co‐carbonization of pre‐oxidized carbon fiber and pitch

Oxidation behavior of in situ TiCp/Ti6Al4V composite with self-assembled network microstructure fabricated by reaction hot pressing

Influence of Oxygen Uptake on Pitch Carbon Fiber

Microstructural investigation and performance of carbon matrix composites developed through facile pitch modification route

Effects of the degree of oxidation of pitch fibers on their stabilization and carbonization behaviors

Oxidation behavior of 3D SiCf/SiBCN composites at 800–1200 °C

Insight into the origin of oxidation behaviors of carbon fiber reinforced carbon aerogel composites with different porous skeletons

Sublimation and oxidation zone ablation behavior of carbon/carbon composites

Effect of oxidation on internal friction behavior of C/SiC composites

Temperature-dependent oxidation kinetics and mechanical properties degradation of Cf/ZrB2-SiC composites

Oxidation Kinetics and Its Impact on the Strength of Carbon Short Fiber Reinforced C/SiC Ceramics

Evaluating of the oxidative behaviors of isotropic pitch fractions for optimal the mechanical properties of isotropic pitch-based carbon fibers

Effects of Process Parameters on Microstructure and Properties of TiC Reinforced Cu-Matrix Composites

Fabrication And Characterization Of A New Pitch-Based Acnt/C Nanocomposites

Mesophase formation of coal-tar pitches used for impregnant of C/C composites

The research on oxidation resistance ability and mechanical properties of carbon fiber reinforced phenolic resin composites

Friction and Wear Properties of Carbon/carbon Composites with Different Martix Carbon

Investigation on promotion effect of oxidative stabilization for pitch‐based fiber by co‐carbonization of coal tar pitch and atmospheric residual

Modification of isotropic pitch by tailoring chemical structure and fraction contents for enhancing carbon fiber mechanical properties

Effect of coal tar pitch as carbon source on the electrochemical performance of silicon-carbon composites