Abstract:Based on the model of long-distance and large-capacity UHVAC line with double-end source, two different methods are used to limit overvoltage and the economical evaluation of the two methods are given. One of them is increasing the number of average subsections of transmission line, namely the overvoltage is limited by only adopting metal oxide arrester (MOA) and HV shunt reactor when opening and closing resistors are not used, and the another one is to limit load-rejection opening overvoltage by adding opening and closing resistors to circuit breakers. Simulation results show that the maximum difference of opening overvoltage levels by the two limiting measures is about 0.04 p.u., so the effects of limiting overvoltage by the two methods are basically the same. Through the measure of increasing subsection number of transmission line the load-rejection opening overvoltage under single-phase earth fault can be limited, however the number of required switching stations is more, so the investment cost is high;through adding opening and closing resistors the same purpose of effectively limiting the overvoltage by lesser subsection number of transmission line can be achieved, meanwhile the number of switching stations can be reduced due to decreasing of the number of subsections of transmission line, so hundreds of millions RMB can be saved, and even the highest saved investment cost may be up to 1 billion RMB. Study results also show that the best value of opening resistor is within the range from 600Ωto 700Ω, thus to limit load-rejection overvoltage it is suitable for long-distance and large-capacity transmission lines to add opening and closing resistors.

Testing Method Research of Transmission Line Parameters

A Parameter Measuring Method of Coupling Transmission Lines Based on the Distributed Parameter Model of Power Transmission Lines

An Impedance Parameters Online Measuring Method of Multi-circuit Transmission Lines on the Same Tower

An Impedance Parameters Online Measuring Method of Asymmetric Transmission Lines

Method for Accurately Measuring the Power-Frequency Parameters of Ehv/Uhv Transmission Lines

Test Method for Lightning Response of Real Transmission Lines

An Estimation Method of Transmission Line Parameters Based on Measurements of Injection Power and Voltage Phasor in Power Grid

Comparative Study on Measures to Limit Load-Rejection Opening Overvoltage of Long-Distance and Large-Capacity UHVAC Transmission Lines

Simulation Analysis of Effectiveness of Radio Interference Measurement on Test Line

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

Fault Location Algorithm for HV Transmission Lines Immune to Saturation of Current Transformers

An Online Measuring Method Of Impedance Parameters Of Asymmetric Transmission Lines

An Approach for Establishing Key Parameter System and Evaluating the State of Transmission Line

A Validity Test Methodfor Transmission Betweens and Transmission Sections Based on Chain Attack Analysisand Line Outage Distribution Factors

State Assessment Method of Transmission Lines Considering Validity of Parameters

Study on the Short Distance Testing Method of Substation Grounding Resistance

Analysis on Electric Parameter Characteristics of Compact Transmission Lines in China

Novel Application of Magnetoresistive Sensors for High-Voltage Transmission-Line Monitoring

Investigation of Transmission Properties on 10-Kv Medium-Voltage Power Lines—Part II: Path Loss

Measurement and research of channel transmission properties on 10 kV medium voltage power lines

A Method for Line Parameter Estimation Based on π-type Equivalent Model