Abstract:A fast and accurate grid impedance measurement of three-phase power systems is crucial for online assessment of power system stability and adaptive control of grid-connected converters. Existing grid impedance measurement approaches typically rely on pointwise sinusoidal injections or sequential wideband perturbations to identify a nonparametric grid impedance curve via fast Fourier computations in the frequency domain. This is not only time-consuming, but also inaccurate during time-varying grid conditions, while on top of that, the identified nonparametric model cannot be immediately used for stability analysis or control design. To tackle these problems, we propose to use parametric system identification techniques (e.g., prediction error or subspace methods) to obtain a parametric impedance model directly from time-domain current and voltage data. Our approach relies on injecting wideband excitation signals in the converter's controller and allows to accurately identify the grid impedance in closed loop within one injection and measurement cycle. Even though the underlying parametric system identification techniques are well-studied in general, their utilization in a grid impedance identification setup poses specific challenges, is vastly underexplored, and has not gained adequate attention in urgent and timely power systems applications. To this end, we demonstrate in numerical experiments how the proposed parametric approach can accomplish a significant improvement compared to prevalent nonparametric methods.

An Estimation Method of Transmission Line Parameters Based on Measurements of Injection Power and Voltage Phasor in Power Grid

A Two-step Method for Estimating DFIG Parameters in a Wind Turbine and the Measurement Selection

Improvements and measurements of parameter identification for electric load

Modeling Methods for Electric Loads in a Real Power Grid

Method for Accurately Measuring the Power-Frequency Parameters of Ehv/Uhv Transmission Lines

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

Synchrophasor Data Analytics: Transmission Line Parameters Online Estimation for Energy Management

Transmission Lines Positive Sequence Parameters Estimation and Instrument Transformers Calibration Based on PMU Measurement Error Model

State Estimation Based Branch Parameter Estimation Method for Power Grid

An On-line Identification and Estimation System for Intelligent Dispatching Power Grid Parameters and Its Application in Guangzhou Power Grid

Power Grid Parameter Estimation Without Phase Measurements: Theory and Empirical Validation

Static parameter estimation and testability analysis of distribution lines based on multi-source measurement information

A Method for Measuring the Potential Near the Ground under a High-Voltage Transmission Line

Estimation of Transient Character for UHV Transmission Line

Topology Identification and Line Parameter Estimation for Non-PMU Distribution Network: A Numerical Method.

Study of the Concept of Transmission Betweenness Considering the Effect of Reactive Power Flow and Its Application in Identification of Critical Lines in Power Grid

Synchrophasor-based Online State Estimated in Large-scale Power Grid

MIMO Grid Impedance Identification of Three-Phase Power Systems: Parametric vs. Nonparametric Approaches

Research on State Estimation Method of Complex Distribution Network

Identification of Distribution Network Topology and Line Parameter Based on Smart Meter Measurements

Voltage Estimation of Distribution Network Based on Mean Impedance Method