Abstract:As motor capacity and rated voltage increase, the demand for motor insulation also increases. Additionally, the electric field distribution at the end of a large-scale hydro generator is extremely nonuniform, and corona discharge occurs. This destroys the main insulation, which significantly affects the service life of electrical machinery. The regulation of the electric field concentration at the end of a large-scale hydro generator needs to be addressed. In this manuscript, a large hydro generator with 120 MW rated capacity and 15.75 kV rated voltage was studied. For the purpose of electric field homogenization in the stator bar end, decrease of highest field strength, and surface loss, the computing methods of the electric field in the stator bar end were studied. The electric field distribution in the stator bar end was obtained. According to COMSOL 5.6 modeling software, the hydro generator stator bar is an accurate model. Using finite element analysis (FEA), the stator bar characteristics can be simulated. The different stator bars with no anti-corona structure, linear anti-corona structure, two-layer nonlinear anti-corona structure, and three-layer nonlinear anti-corona structure were compared, including the electric potential, electric field, and loss distribution under rated voltage. From the experimental results, with no anti-corona structure and linear anti-corona structure, the electric field concentration is present in the exit slot. The values of electric field and loss are both higher, which causes corona discharge easily. With the nonlinear anti-corona structure, the electric field concentration is improved significantly, effectively decreasing the highest electric field. The three-layer nonlinear anti-corona structure is the best. Compared with the two-layer nonlinear anti-corona structure, the values of the highest electric field and loss are 16% and 77% lower, respectively.

DISTRIBUTION OF ELECTRIC FIELD AT THE WINDING END OF GENERATOR STATOR

Analytical investigation of open-circuit eddy current loss in windings of PM machines

Analysis and Mitigation of Fault-Induced Electromagnetic Force Effect on PM Modules in Integral-Slot Wind Generators

Optimization of Transposition in Stator Bars of Hydro-Generators

Optimization of the Electric Field Distribution at the End of the Stator in a Large Generator

Insulation safety analysis based on the novel generator stator model

3-D Eddy Current Analysis in the End Region of a Turbogenerator by Using Reduced Magnetic Vector Potential

An Application Study of a New De-Excitation Method for Generator with Self-Shunt Excitation

Electromagnetic Design And Optimization Of Dual-Stator Brushless Doubly-Fed Wind Power Generator With Cage-Barrier Rotor

A Novel Nonlinearly Equivalent Circuit Model for Calculating Electric Fields Along the Stator End-winding of HV Rotating Machine

3D finite element study of transient electromagnetic forces acting on the stator end-windings of a large turbo-generator

Hydro Generator Stator Bar Modeling and Simulation Based on Finite Element Simulation

Voltage Distribution Analysis of High Dv/dt Fed Machines Using High Frequency Winding Model

Design Of A Dual-Stator Superconducting Permanent Magnet Wind Power Generator With Different Rotor Configuration

Design Aspects for Permanent Magnet Superconducting Wind Power Generators

Study on the Electromagnetic Field and Losses in the End Zone of Large Hydraulic Generators by FEM

Online Monitoring of Inter-turn Short Circuit Fault of Field Winding in Large Turbo-generator

Analysis of Unbalance of Three-phase Leak Current in DC Dielectric Test of 1 000 MW Generator Stator in Nuclear Power Plant

Study on Electromagnetic Forces of End Windings in Large Turbo-Generators

Effects of Stator Winding Configurations on Steady-state Currents Characteristics of Synchronous Generator With Inter-turn Short Circuits of Field Windings

Experimental Study On Single-Phase Grounding Fault Safety Current Of Large Generators