Abstract:The composite crossarm insulator differs greatly from the suspension insulator in structure and arrangement. This study aims to determine the pollution flashover characteristics of composite crossarm insulators under different voltage grades. Four types of AC composite crossarm insulators with diameters ranging from 100 mm to 450 mm are subjected to artificial pollution test, and then the effects of the surface hydrophobicity state of silicone rubber, core diameter, umbrella structure, arrangement, and insulation distance on the pollution flashover voltage of the composite crossarm insulators are analyzed. Under the pollution grade 0.2/1.0 mg/cm2 and voltage grade from 66 kV to 1000 kV, if the silicone rubber surface changes from HC5 to HC6, the pollution flashover voltage of the composite crossarm insulator will increase by 13.5% to 21.0% compared with the hydrophilic surface. If the core diameter changes from 100 mm to 300 mm, the pollution flashover voltage gradient decreases with the increase in core diameter; if the core diameter changes from 300 mm to 450 mm, the pollution flashover voltage gradient increases with core diameter. Under the same insulation height and core diameter, the umbrella structure will have a certain impact on pollution flashover voltage by up to 1.7% to 5.4%. Under the horizontal arrangement, the pollution flashover voltage can increase by 10.5% to 12.1% compared with that under the vertical arrangement. Under the hydrophilic surface and weak hydrophobicity state, the pollution flashover voltage has a linear relationship with the insulation distance. The above results can provide a reference for the structural design and optimization of the composite crossarm insulator.

AC Flashover Performance of Contaminated Insulators in Hot Water Vapor Washing

Flashover of Composite Insulators Without Hydrophobicity under Heavy Ice and the Secondary Contamination Conditions

Flashover Characteristics of a Hydrophobic Surface Covered by Water

Wet Flashover Characteristic of Composite Post Insulators at High Altitudes

Pollution Flashover Characteristics of Composite Crossarm Insulator with a Large Diameter

Calculation of DC and AC Flashover Voltage of Polluted Insulators

Analysis On Flashover Performance Of Polluted Porcelain Insulators In High Conductivity Fog Environment

Experimental Verification on the Assessment System of Outdoor Insulation State of Saturated Moist Insulator

Revealing the flashover mechanism of EP/GF composite insulation under DC combined harmonic voltage

DC Flashover Performance of ±800 Kv Composite Post Insulator in High Altitude Area

Effect of Arcing on DC Flashover Performance of Contaminated Porcelain Insulators for Various Suspension Patterns at High Altitudes

Influence of Environmental Temperature on Flashover Voltage of Composite Insulator

Wetting Characteristics of the Hydrophobic Material Surface Through Condensation

Mechanism of contaminant accumulation and flashover of insulator in heavily polluted coastal area

Influence Factors of Hydrophobicity and DC Flashover Performance for Composite Insulators

Pollution Flashover Characteristics of the Insulators Of±800 Kv HVDC Lines under High Altitude Areas

Investigation on Altitude Correction Factor of Flashover Voltage of Porcelain Insulator for DC Transmission Lines

DC pollution flashover and rain flashover performance for composite post insulators at high altitudes

A Study on the Discharge along RTV Coated Insulators

An experimental study of the flashover performances of outdoor high-voltage polymeric insulators under fan-shaped pollution and dry band location

Flashover Performance of Pre-contaminated and Ice-covered Composite Insulators to be Used in 1000 kV UHV AC Transmission Lines