Abstract:Functional Materials Letters, Ahead of Print. BaTiO3/Nb:SrTiO3 thin film oxides have been deposited on SrTiO3 substrates using a pulsed laser deposition system. Different annealing methods were thereafter used to assess the ferroelectricity of the grown films. The residual polarization value, 2Pr, of 4.205 [math]C/cm2 and saturated residual polarization value, 2Pmax, of 15.484 [math]C/cm2 were obtained using in-situ annealing. After performing rapid thermal annealing (RTA) annealing, the residual polarization value rose to 4.676 [math]C/cm2 and the saturated residual polarization value rose to 18.723 [math]C/cm2. Furthermore, a comparison of results showed that the saturation test frequency of the in-situ annealing was 10 times higher than the saturation test frequency of the RTA. This could be explained by the fact that the secondary high-temperature annealing led to a decrease in the conductivity of the doped oxide and, thereby, a decrease in the effective electric field that was applied to both ends of the BTO (BaTiO3) film. Thus, a lower frequency was required to ensure a flip of all ferroelectric domains within the BTO film. By testing the fatigue frequency at 100 kHz, 10[math] stable cycles in both annealing methods and the results confirmed the good stability of the device performance. A linear fit analysis of the [math]–[math] curves showed under in-situ annealing the presence of both a bulk-limited current mechanism that was dominated by the space charge limited current (SCLC) and Pool–Frenkel (PF) mechanisms, and an interface-limited current that was dominated by the Fowler–Nordheim (FN) mechanism in the structure. After RTA annealing, the conducting mechanism is ohmic contact at low electric field and the SCLC mechanism at high field strength. The results show that after RTA annealing, the quality and ferroelectric properties of the films are significantly improved compared to those under in-situ annealing. These results showed that the BTO/NSTO/STO (BaTiO3/Nb:SrTiO3/SrTiO3) structure had a standard test frequency as well as reliable stability. The BTO/NSTO/STO structure showed, therefore, promising applications in future nonvolatile information memory devices.

EFFECT OF HEAT TREATMENT PROCESS ON PROPERTIES OF CALCIUM STRONTIUM BISMUTH TITANATE FERROELECTRIC THIN FILMS

PREPARATION OF CALCIUM DOPED STRONTIUM BISMUTH TITANATE FERROELECTRIC THIN FILMS BY SOL-GEL PROCESSING

Effects of Annealing Temperature on the Structures, Ferroelectric and Magnetic Properties of Aurivillius Bi5ti3feo15 Polycrystalline Films

Effect of the Sintering Temperatures on the Properties of the Ca0.6Sr0.4Bi4Ti4O15 Ferroelectric Ceramics

Effect of different Bi contents on properties of CaBi4Ti4O15 ferroelectrics thin films

Effect of annealing temperature on the properties of 0.5Bi4Ti3O12-0.5BiFe0.98Mn0.02O3 thin films

Influence of Annealing on Crystal Structure and Properties of SrBi 2 Ta 2 O 9 Thin Films Prepared by Pulse Laser Deposition

Growth and ferroelectric properties of strontium bismuth tantalite thin films using pulsed laser deposition combined with an annealing process

THE STABILITY INVESTIGATION OF FERROELECTRIC SrBi2Ta2O9 THIN FILMS ANNEALED IN FORMING GAS

Effect of Annealing Temperature on Properties of Barium Zirconium Titanate Thin Films Deposited by Sol-Gel Method

0.75Srbi2ta2o9-0.25Bi3titao9 Layered Structural Thin Films: Microstructure and Ferroelectric Properties

Ferroelectric properties and current mechanisms of BaTiO[math]/Nb:SrTiO[math] thin films

Annealing temperature effect on internal strain and ferroelectric properties of Bi3.25La0.75Ti3O12 thin films

Stability investigation of ferroelectric SrBi2Ta2O9 thin films annealed in forming gas

Structure and Voltage Dependence of Ferroelectric Properties of SrBi2Ta2O9 Thin Films

Effect of Different Sintering Temperatures on the Electrical Properties of SBTi Ferroelectric Ceramics

Ferroelectric properties of sol-gel derived Ca1-xSr xBi4Ti4O15 thin films

Time effect on the ferroelectric properties of SrBi2Ta2O9 thin films in forming gas processing

Effects of anneal atmosphere on the structural and ferroelectric properties of SrBi2Ta2O9 thin films

The influence of film thickness and process temperature on c -axis orientation of Bi 3 TiTaO 9 thin films

Effect of annealing temperature on the energy storage properties of Ba(Zr0.35Ti0.65)O3 thin films prepared by sol–gel method