Abstract:The monotonic tensile properties and deformation mechanisms of Fe–Mn–C twinning-induced plasticity (TWIP) steels have been extensively studied; however, the low-cycle fatigue (LCF) properties of this series of advanced steels have not been well understood. The present paper addresses the cyclic deformation behavior and the deformed microstructure of an as-annealed TWIP steel. Fully reversed push–pull LCF tests were performed at room temperature under total strain amplitude control with a strain rate of 0.006s−1 and strain amplitudes ranging from 0.002 to 0.01. The results show initial rapid cyclic hardening within the initial 10% of the fatigue life at all strain amplitudes, and demonstrate an obviously enhanced cyclic yield strength. Different types of cyclic stress responses were revealed, which are featured by initial cyclic hardening followed by cyclic saturation, or followed by cyclic softening and saturation, or followed by cyclic softening without saturation till the final fracture, depending on the strain amplitude applied. The microstructure prior to and after fatiguing were examined by means of optical and transmission electron microscopy. The typical optical microstructure of fatigued samples is characterized by increases in slip band density with increasing strain amplitude or number of cycles at a given strain amplitude applied. The substructures of the deformed samples are featured by the formation of stacking faults and vein/labyrinth dislocation structures, while fine twins and cell or wall dislocation structures, besides those generated at lower strain amplitudes, are formed at high strain amplitudes.

Effect of Deformation Twins on Fatigue Property of 50CrV4 Auto Spring Steel

Effects of low-cycle fatigue on static mechanical properties, microstructures and fracture behavior of 304 stainless steel

In Situ Nanomechanical Testing of Twinned Metals in a Transmission Electron Microscope

Multi-scale Deformation Behavior Investigation of 18cr–8ni Austenitic Steel Subjected to Low-Cycle Fatigue Loading

Variation In Mechanical Properties, Microstructures And Fracture Behavior Of 304 Stainless Steel During Low-Cycle Fatigue

Cracking in a Fe–25Mn–3Si–3Al Steel

Fatigue failure analysis and finite element assessment of the twins torsion spring

Transmission electron microscopy observation of a deformation twin in TWIP steel by an ex situ tensile test

On the Deformation Mechanism of Twinning-Induced Plasticity Steel

Towards revealing the relationship between deformation twin and fatigue crack initiation in a rolled magnesium alloy

Gigacycle Fatigue Behavior of 1800 MPa Grade High Strength Spring Steel for Automobile Lightweight

Effects of Twin-Dislocation and Twin-Twin Interactions on the Strain Hardening Behavior of TWIP Steels

Fatigue fracture behaviour of a medium-carbon 2 000 MPa level high strength spring steel

Low-Cycle Fatigue Behavior of A High Manganese Austenitic Twin-Induced Plasticity Steel

Simulation and Microstructural Analysis of Twin-Induced Plasticity Steel Cylinder Deep Drawing

Ultra High Cycle Fatigue Behavior of Automotive High Strength Spring Steels 54sicrv6 and 54Sicr6

On the Microstructure Evolution During Low Cycle Fatigue Deformation of Wrought ATI 718plus Alloy

Effect of Grain Size on Twinning Behavior in Ti–2Al–2.5Zr Alloy Fatigued at 77K

Effect of High-Temperature Deformation Twinning on the Work Hardening Behavior of Fe-38Mn Alloy during Hot Shear-Compression Deformation

Effect of Inclusion Size on High-Cycle Fatigue Behavior of High Strength Spring Steel

High-Cycle Fatigue Properties of 60Si2CrVA Spring Steels Produced by Two Different Metallurgical Processes