Abstract:The fatigue fracture behavior of four ultrahigh strength steels with different melting processes and therefore different inclusion sizes were studied by using a rotating bar two-point bending fatigue machine in the high-cycle regime Up to 10(7) cycles of loading. The fracture surfaces were observed by field emission scanning electron microscopy (FESEM). It was found that the size of inclusion has significant effect on the fatigue behavior. For AISI 4340 steel in which the inclusion size is smaller than 5.5 mu m, all the fatigue cracks except one did not initiated from inclusion but from specimen surface and conventional S-N curve exists. For 65Si2MnWE and Aermet 100 steels in which the average inclusion sizes are 12.2 and 14.9 mu m, respectively, fatigue cracks initiated from inclusions at lower stress amplitudes and stepwise S-N curves were observed. The S-N curve displays a continuous decline and fatigue failures originated from large oxide inclusion for 60Si2CrVA steel in which the average inclusion size is 44.4 mu m. In the case of internal inclusion-induced fractures at cycles beyond about 1x10(6) for 65Si2MnWE and 60Si2CrVA steels, inclusion was always found inside the fish-eye and a granular bright facet (GBF) was observed in the vicinity around the inclusion. The GBF sizes increase with increasing the number of cycles to failure N-f in the long-life regime. The values of stress intensity factor range at crack initiation site for the GBF are almost constant with N-f, and are almost equal to that for the surface inclusion and the internal inclusion at cycles lower than about 1x10(6). Neither fish-eye nor GBF was observed for Aermet 100 steel in the present study.

Fatigue fracture behaviour of a medium-carbon 2 000 MPa level high strength spring steel

Variation In Mechanical Properties, Microstructures And Fracture Behavior Of 304 Stainless Steel During Low-Cycle Fatigue

Effects of low-cycle fatigue on static mechanical properties, microstructures and fracture behavior of 304 stainless steel

Effect of Inclusion Size on High-Cycle Fatigue Behavior of High Strength Spring Steel

Ultra high cycle fatigue behavior of a medium-carbon high strength spring steel NHS1

Very High Cycle Fatigue Behaviour of 2000‐mpa Ultra‐high‐strength Spring Steel with Bainite–martensite Duplex Microstructure

High-Cycle Fatigue Fracture Behavior of Ultrahigh Strength Steels

Gigacycle Fatigue Behavior of 1800 MPa Grade High Strength Spring Steel for Automobile Lightweight

Failure Behavior of Ultra-high Cycle Fatigue of a 2 000 MPa Grade High Strength Steel

Ultra High Cycle Fatigue Behavior of Automotive High Strength Spring Steels 54sicrv6 and 54Sicr6

Fatigue Fracture Behavior of High Strength Cr-Mo-V Steel

Fatigue Properties of the Ultra-High Strength Steel TM210A

High-Cycle Fatigue Properties of 60Si2CrVA Spring Steels Produced by Two Different Metallurgical Processes

High-cycle Bending Fatigue Behaviour of Nanostructured Bainitic Steel

Influence of Non-Metallic Inclusions on Very High-Cycle Fatigue Performance of High-Strength Steels and Interpretation via Crystal Plasticity Finite Element Method

Low-cycle Fatigue Testing and Microstructure of High Strength-Ductility Structural Steel Materials

High Cycle Fatigue Behavior of Medium-Carbon Trip Steel at Different Tensile Strength Levels

Fatigue crack initiation and competitive crack propagation behavior in 500 MPa grade automobile beam steel

Study on Inclusion Induced Fatigue Crack Initiation and Propagation in Ultra-High Strength Steel for Aerospace Application

Very High Cycle Fatigue Behavior of 25cr2ni2mov Steel Welded Joint

Torsional fatigue behaviour and damage mechanisms of martensitic spring steel in the HCF regime