Abstract:Ti-2Al-2.5Zr alloy with hcp structure is a kind of structural materials used under low temperature condition, e.g. pipeline system of liquid hydrogen and liquid oxygen in missile engine. It is usually serviced in condition of severe low temperature and dynamic loading. Deformation twinning is a common and important plastic deformation mode in the hexagonal close-packed alloy., but will be severely restricted as the grain is refined from tens of microns to a few microns. On the other hand, twinning has a low sensitivity to temperature, consequently becomes a favorable deformation mode at low temperature in comparison with dislocation slip. The objective of this work is to study the coupling effect of grain refinement and testing temperature on twinning behavior and the low-cycle fatigue behavior of Ti-2Al-2.5Zr.Symmetrical push-pull low-cycle fatigue (LCF) tests were performed on Ti-2Al-2.5Zr with grain size of about 5 pm at room temperature (RT) and low temperature (77 K). The results show that the alloy exhibits the higher ductility and the longer low-cycle fatigue life at 77 K than those at RT. The cyclic stress response curves show that the cyclic softening occurs at the low strain amplitudes of 0.5% and 1.0%. However, as strain amplitude increased to 1.5% and 2.0%, cyclic stress saturation appeared. When testing temperature declined to 77 K, the cyclic hardening was observed at all four strain amplitudes. The degree of cyclic hardening increases as the strain amplitude rises. The fractography analyses suggest that transgranular fracture with well-developed fatigue striations is the predominant failure mode. The amount of secondary cracks is much higher in the alloys deformed at RT than that at 77 K. TEM examination reveals that deformation twins become more active. The primary types of twinning are {10 (1) over bar1} and {11 (2) over bar1}. The typical deformation microstructures consist of individual dislocation lines together with the tangled dislocation at the low strain amplitudes of 0.5% and 1.0%. As the strain amplitude increased to 1.5% and 2.0%, {10 (1) over bar0} prismatic slip and {11 (2) over bar1} pyramidal slip were simultaneously activated, the subgrain and dislocation cells were formed. At 77 K and strain amplitude of 2.0%, the parallel dislocation bands distribute along prismatic plane. As the strain amplitude increased to 4.5%, mutua l perpendicular dislocation lines appeared. The improvement of fatigue life of Ti-2Al-2.5Zr at 77 K is attributed to the constraint of inhomogeneous slip and the activation of deformation twinning.

Effect of Grain Size on Twinning Behavior in Ti–2Al–2.5Zr Alloy Fatigued at 77K

Effect of Grain Size and Testing Temperature on Low-Cycle Fatigue Behavior and Plastic Deformation Mode of Ti-2Al-2.5Zr

LOW CYCLE FATIGUE BEHAVIORS AND MICROSTRUCTURES OF Ti–2Al–2.5Zr WITH FINE GRAIN AT RT AND 77 K

Statistical Analysis Of Grain-Scale Effects Of Twinning Deformation For Magnesium Alloys Under Cyclic Strain Loading

Low-cycle fatigue behavior and deformation substructure of Ti-2Al-2.5Zr alloy at 673 K

Low-Cycle Fatigue Behavior and Deformation Substructure of Ti-2al-2.5zr Alloy at 298 and 673K

Investigation of Neighboring Grain Effects on Load Shedding in Titanium Alloys under Cold Dwell Fatigue

Low-cycle Fatigue Behavior and Property of TA15 Titanium Alloy with Tri-Modal Microstructure

Low-cycle Fatigue Behavior and Deformation Substructure of Ti-2Al-2.5Zr Alloy at 673K

Effect of the Initial Grain Size on Grain Refinement in Ti–2Al–2.5Zr Alloy Subjected to Multi-Impact Process

Effect of Interface Type on Deformation Mechanisms of Γ-Tial Alloy under Different Temperatures and Strain Rates by Molecular Dynamics Simulation

Effect of Grain Size on the Plastic Deformation Behaviors of a Fe-18Mn-1.3Al-0.6C Austenitic Steel

Effect of grain structure and precipitate on tensile properties and low-cycle fatigue behaviors of 2A55 Al-Cu-Li alloy

Influences of Grain Size on the Deformation Behavior of a Twinning-Induced Plasticity Metastable Β Titanium Alloy

Effect Of Grain Size On The Superplastic Deformation Behavior Of Ti-55 Alloy

Alloying Effect on Grain-Size Dependent Deformation Twinning in Nanocrystalline Cu–Zn Alloys

Grain Size Effect on Deformation Twinning and De-Twinning in A Nanocrystalline Ni-Fe Alloy

Low Cycle Fatigue Behavior and Deformation Mechanism of Ti–6Al–4V-0.55Fe Alloy under the Control of Strain and Stress Amplitudes

Microstructure Evolution and Deformation Behavior of Ti-7mo-3al-3cr-3nb Alloy with Different Β Grain Sizes During Tensile Deformation

Twinning behavior in lamellar gamma-TiAl alloy deformed cyclically at room temperature

Effect of Grain Size on Hot Deformation Behavior of a New High Strength Aluminum Alloy