Abstract:An errors-in-variables regression method is presented as an alternative to the ordinary least-squares regression computation currently employed for determining the calibration function for force measuring instruments from data acquired during calibration. A Monte Carlo uncertainty evaluation for the errors-in-variables regression is also presented. The corresponding function (which we call measurement function, often called analysis function in gas metrology) necessary for the subsequent use of the calibrated device to measure force, and the associated uncertainty evaluation, are also derived from the calibration results. Comparisons are made, using real force calibration data, between the results from the errors-in-variables and ordinary least-squares analyses, as well as between the Monte Carlo uncertainty assessment and the conventional uncertainty propagation employed at the National Institute of Standards and Technology (NIST). The results show that the errors-in-variables analysis properly accounts for the uncertainty in the applied calibrated forces, and that the Monte Carlo method, owing to its intrinsic ability to model uncertainty contributions accurately, yields a better representation of the calibration uncertainty throughout the transducer’s force range than the methods currently in use. These improvements notwithstanding, the differences between the results produced by the current and by the proposed new methods generally are small because the relative uncertainties of the inputs are small and most contemporary load cells respond approximately linearly to such inputs. For this reason, there will be no compelling need to revise any of the force calibration reports previously issued by NIST.

Long-term stability and accuracy of build-up force standard machine

The Design Study of Single Plane Vertical Hard Bearing Dynamic Balancing Machine

Study on Calibration Method and System Error Compensation of Balancing Machines

A United Kinematic Calibration Method for a Dual-Machine System

Local Calibration of a Weak Stiffness On-Machine Measuring Device with a New 3-D Calibrator

Classification and verification of direct shear and strength-test apparatus for multi-scale rock mass discontinuity

Research on Finite Element Calibration Technology of Calibration Coefficients in Hole-drilling Method

Registration Error Analysis and Evaluation in Large-Volume Metrology System

The Device for Calibration Based on the Six-freedom of Generalized Force

Preparation of 3 MN Build-Up Force Standard Machine

Calibration of the Effective Spring Constant of Ultra-Short Cantilevers for A High-Speed Atomic Force Microscope

Evaluating metrological performance of a pressure balance utilizing a high-precision force transducer: an experimental study

A study on the stability bearing capacity of fastener-style tubular steel formwork-supports

Preparation of 50 Kn Specialized Standard Force Device at CQMQ

Verification of A Multiple-Machine Program for Material Testing from Quasi-Static to High Strain-Rate

Accuracy Assessment of Semi-Automatic Measuring Techniques Applied to Displacement Control in Self-Balanced Pile Capacity Testing Appliance

Force calibration using errors-in-variables regression and Monte Carlo uncertainty evaluation

Latest Development of A New Standard for the Testing of Five-Axis Machine Tools Using an S-Shaped Test Piece

Comparison and Analysis of Different Methods in Calibration of the Spring Constant of AFM Cantilever Probes

Accurate Kinematics Calibration Method for a Large-Scale Machine Tool

Accuracy of the Parallel Reset Mechanism in a Wind Tunnel Balance Calibration System