The Desgin of New Multifunctional IP-phone

钱敏,黄乡生,张福柳

DOI: https://doi.org/10.3969/j.issn.2095-3046.2002.04.008

2002-01-01

Abstract:This paper introduces a new type of IP telephone designed by us.The telephone is made up of PHILIPS single-chip and some other special IC.It may make dialing IP call more convenient and can be used in200,300,301cards' dialing.

What problem does this paper attempt to address?

Design of IPPBX based on embedded system

Yuemei YANG,Pingshan CHEN,Dongqin FENG

DOI: https://doi.org/10.16652/j.issn.1004-373x.2015.12.022

2015-01-01

Abstract:With the packet exchange principle,IPPBX can realize the functions of the traditional PBX on Ethernet and overcome the insufficiency of traditional PBX effectively. It has powerful functions,comprehensive services with less cost. The typical networking mode of IPPBX is introduced in this paper. The design principles of each module system MPC8250 hardware system based on IPPBX and the software system of the system are given. The protocol conversion software of main con?trol module is also analyzed. The test result shows that the system can achieve simultaneous processing of 200 calls and its voice quality is excellent.
Design of portable infrared business card exchange system on chip

Yan Han,Minwen Shi,Hongyue Du,Hong Yu

DOI: https://doi.org/10.1109/icsict.2004.1436804

2006-01-01

Abstract:To be different from the universal asynchronous design in multichip, a new-style design of the synchronous system on monolithic chip is presented to apply to exchange and management of business cards in this paper. Every part is accomplished and some improvement is made in the circuits to decrease power consumption. In addition, we adopt SOC (system on chip) design to reduce fabrication and system test costs, introduce a controllable high-speed infrared driver to enhance the security and quality of communication, and design reduced instruction set to enhance the quality and efficiency of business cards management and depress systematic redundancy. This chip is fabricated in 0.6 μm mixed-signal CMOS process (double poly, double metal), packaged as well as tested primarily.
Design and Implementation of Distributed VoIP Architecture Based on SIP Protocol

张旭光,平玲娣,潘雪增

DOI: https://doi.org/10.3969/j.issn.1000-3428.2004.14.037

2004-01-01

Abstract:With the development of the Internet technologies and computer communication technologies, the traditionary circuit-switch based network must evolves to the new generation network which is based on the packet-switch technology. Facing the progress and status of the convergence of the three-networks, This document presents a distributed and SIP protocal based VoIP system prototype. Due to combinating of merits of SIP and IP, this model not only provides the interoperation with the existed network, but also provides an extendable plat for the NGN. This model uses private VoIP network to achieve the QoS.
Design of IP Telephone Based on TMS320C5402

侯建军,柳立鹏,邵文龙

DOI: https://doi.org/10.3969/j.issn.1673-0291.2001.03.028

2001-01-01

Abstract:A DSP-based solution to LAN/Intranet-oriented IP telephone is presented. This IP Telephone can be used either as a desktop PC peripheral or as an Intranet network terminal. Its cores are TMS320C5402 in charge of voice code and MPC860T in charge of communications protocol processing and control logic. Several kinds of interface including USB, RS232 and RJ45 are designed to allow IP telephone to connect with other equipment in flexible ways. Some details of hardware architecture are discussed in this paper.
Design of Television with IP Video Phones

梁元,郭科,李建平,钟守铭

DOI: https://doi.org/10.3969/j.issn.1002-8692.2009.01.019

2009-01-01

Abstract:A video telephon module is added on TV platform Trident WX68.And thus, a TV with IP video phone function is designed.The main chip used in video telephony module is TMS320DM6446 of TI company.Finally, the experimental results prove the feasibility of this design.
Design of Infrared Business Card Exchanger Chip

CHEN Ming,HAN Yan

DOI: https://doi.org/10.3969/j.issn.1001-9146.2006.05.014

2006-01-01

Abstract:This paper introduces the design of a special business card management chip,which adopts point-to-point infrared wireless data communication technology.The new chip can improve the efficiency of business cards management,improve the security and quality of the infrared communication,and simplifies the operation.The chip has been taped out(using a 5V 0.6um CMOS mix-signal double well,double poly,double metal technology) and tested.
LDAP-based IP-Phone Distributed Callcenter Design

环翾,田瑞雄,赵明生,李星

DOI: https://doi.org/10.3969/j.issn.1001-3695.2001.12.034

2001-01-01

Abstract:We apply LDAP to the callcenter design of the practical IP-Phone system Cool-Audio, and present a LDAP-based IP-Phone distributed callcenter design. This design shows the features of good expandability, reliability and efficiency.
The Design of MDF Remote Intelligent Supervisor System with S3C44B0X

LIN Ying-zi,XU Yuan-xin,WANG Kuang

DOI: https://doi.org/10.3969/j.issn.1671-7147.2005.03.007

2005-01-01

Abstract:MDF remote intelligent supervisor system reduces administrators redundance and facilitates concentrating management of the distributed switching offices,which monitors malfunction of the remote office and transfers the messages to the center office. This system adopted ARM7TDMI-S3C44B0X as main processor produced by SAMSUNG Corp. The communication method between center machine and the remote one is based on Ethernet. The paper elaborates the system scheme and the realization of network communication.
Design and Realization of the Ethernet Phone Based on SDA80D51

贾德胜,黄永峰

2005-01-01

Abstract:An Ethernet IP phone design was introduced in this paper. The design used SDA80D51 as the MCU and DSP unit to realize an efficient Ethernet phone. Some advice on the program of the MCU system was also given.
Design and Realization of Conference System Based on IP Video Phone

熊平华,杨建刚

DOI: https://doi.org/10.3969/j.issn.1000-7024.2004.04.042

2004-01-01

Abstract:Beginning from the ITU H.323 multimedia communication protocol and the hardware and software architecture of a MCU system, a IP video phone conference system based on the H. 323 protocol was introduced, which is a embedded system de-signed for special requirement. To enhance the utilization performance of network resource, the grouping exchange technology was applied in the network layer in this system. It was specially put forward a double process boards hardware structure-the sup-port hardware for audio/video encode and decode, data encapsulate etc was integrated in the mother board and the communication function with the network in the subsidiary board. The two boards communicate with data stream mechanism and the software system was also drived by data stream. High reliability , low cost and good transplantation to the realization of IP video phone conference system were provided, which was meaningful used to reference by similar small video conference system research and development.
A Design and Implementation of 32-Way MFC/DTMF Transceiver

HOU Jian-jun,SHAO Wen-long,LIU Li_peng

DOI: https://doi.org/10.3969/j.issn.1673-0291.2001.02.020

2001-01-01

Abstract:A design and implementation of 32_way MFC/DTMF transcei ver system in a small board, which fitted in the main control board is introduc ed in this paper. It can be used in middle or small scale CTI switches. Compare thi s wit h the implementation of ASIC, this system has smaller volume, higher processing density, and has higher performance-cost ratio and flexible interface.
Implementation of IP Video Telephone Terminal Based on H.323

刘峰,唐慧明,刘建军

DOI: https://doi.org/10.3969/j.issn.1000-3428.2003.08.056

2003-01-01

Abstract:A video IP telephone terminal based on H.323 is described in this paper. It is in compliance with the video compression standards H.263/H.261 and the audio compression standards G.711/G.723.1/G.729. The new generation DSP chip TM1300 of Philips is used in this undependent terminal.
Triple-play Switchboard IP Phone Business Achievement Based on Sip Call

Zhigang Wang,Wenfang Li

DOI: https://doi.org/10.1109/icmt.2011.6002286

2011-01-01

Multimedia Technology

Abstract:It describes the implementation process of SIP voip call in the triple-play switch and discusses the transplantation and application of the osip stack in the Linux system, meanwhile, it proposes an embedded SIP switch application in the PSTN call processing and gives the realization diagram and solutions, which has some significance in SIP development.
Design of Telecommunications System Based on 89C51 and Modem

毛兴鹏,戴伏生,徐勇

DOI: https://doi.org/10.3969/j.issn.1005-2992.2002.02.018

2002-01-01

Abstract:A new tel-communication method based on 89C51 is proposed,which allows a low cost data transmission that can be realized by using MODEM and E 2PROM.The historical data collected by Single Chip Microcomputer,which can be controlled by PC,may be transmitted to PC anytime.
The Multifunctional Card of DTV Receiver Based on Wireless Network and PCMCIA Interface

但唐仁,刘岩

DOI: https://doi.org/10.3969/j.issn.1672-6332.2008.04.013

2008-01-01

Abstract:The paper introduces a kind of DTV receiver card which combines the technology of the terrestrial DTV channel demodulator,DTV demux and decoder,GMS/CDMA communication,portable reception design and PCMCIA interface.Associating the specialty of mobile telephone and wide band reception of terrestrial DTV,the function of bi-directional wireless alternant is achieved on the notebook PC.
A Call Control Module Design Based on SIP

FENG Tao,FU Jian-xun,LU Jian-hua,WANG Dong-hai

DOI: https://doi.org/10.3969/j.issn.1001-893x.2007.01.041

2007-01-01

Abstract:This paper introduces the design of a call control module which uses SIP and is mainly used in wireless LAN(WLAN).The design by programming is tested and comparison with other products is made.It is proved that this design has great capability in many aspects.
Design of Phonic Communication System Based on AMBE2000

倪彦文,金向东

DOI: https://doi.org/10.3969/j.issn.1002-8684.2005.01.011

2005-01-01

Abstract:The paper describes the encoding of MBE and the function of AMBE2000 briefly, and a set of telephone terminal system is designed based on AMBE2000 circuits of telephone user interface. Phonic PCM digital-encoding and the circuits supported by AMBE2000 are given.
Design and Implementation of Visual IP Video Phone Terminal Based on Android

SHAO Changbin,ZHANG Chongyang,ZHENG Shibao

DOI: https://doi.org/10.3969/j.issn.1002-8692.2011.06.020

2011-01-01

Abstract:The design and implementation scheme of embedded visual IP phone terminal is proposed.The IP video phone terminal runs on Android and the embedded platform which uses the multimedia processor i.mx27 as its master chip.The terminal supports SIP,and also supports video and audio communication bi-directionally.
Design of simplex wireless call and data transmit system based on MCU

Li Jie

Abstract:Based on MCU, a simplex wireless call and data transmit system is designed by analog frequency modulation technique. In the frequency interval of 30～40 MHz, the transmittal of long distance and simplex by small power that voice signals are inputted through microphone and line is realized. The host and subordinate machines can undertake smart communication by frequency shift keying(FSK)modulation mode. There are 256 subordinate stations in our architecture, forming a one-to-multiple point, simplex, wireless call system. There is no obvious distortion and low bit error rate during transmittal. The number of subordinate stations can optionally change, while the host station can selectively or wholly dial-up. Data transmits while voice signals communication in this system. The English words, Chinese characters, short messages and station number will be displayed on liquid crystal display(LCD).

Computer Science,Engineering

The Desgin of New Multifunctional IP-phone

Design of IPPBX based on embedded system

Design of portable infrared business card exchange system on chip

Design and Implementation of Distributed VoIP Architecture Based on SIP Protocol

Design of IP Telephone Based on TMS320C5402

Design of Television with IP Video Phones

Design of Infrared Business Card Exchanger Chip

LDAP-based IP-Phone Distributed Callcenter Design

The Design of MDF Remote Intelligent Supervisor System with S3C44B0X

Design and Realization of the Ethernet Phone Based on SDA80D51

Design and Realization of Conference System Based on IP Video Phone

A Design and Implementation of 32-Way MFC/DTMF Transceiver

Implementation of IP Video Telephone Terminal Based on H.323

Triple-play Switchboard IP Phone Business Achievement Based on Sip Call

Design of Telecommunications System Based on 89C51 and Modem

The Multifunctional Card of DTV Receiver Based on Wireless Network and PCMCIA Interface

A Call Control Module Design Based on SIP

Design of Phonic Communication System Based on AMBE2000

Design and Implementation of Visual IP Video Phone Terminal Based on Android

Design of simplex wireless call and data transmit system based on MCU