Abstract:We propose a near-zero-power temperature sensor only by using standard CMOS transistors without any resistor and special device or process. A pair of temperature sensing elements by employing the normal CMOS transistors is adopted to generate the proportional-to-absolute temperature (PTAT) and constant with temperature (CWT) sensing voltages. Then the two sensing voltages are converted to two reference current sources by using the proposed ultra-low-power voltage-to-current (VI) converter. The VI converter converts the linear voltage signal to an exponential current source with a constant exponent coefficient by using CMOS transistors instead of the conventional resistors. As a result, both power loss and chip area are saved. The whole temperature sensor is designed in standard 0.18 pm CMOS process with active area of only 0.017 mm 2 . The supply voltage is 600 mV. After 1-point calibration, an accuracy of ±0.24 °C is achieved across the temperature range of 0 °C - 80 °C. The power consumption is only 22 pW for the sensing element, 25 pW for VI converter and 80 pW for total at room temperature (27 °C). The good performance and ultra-small facility of the temperature sensor shows its good practicality for Internet-of-Thing (IoT) applications.

An Ultra-Low Power Temperature Sensor Based on Relaxation Oscillator in Standard CMOS

An All-Digital CMOS Temperature Sensor with a Wide Supply Voltage Range.

A Low Power Low Supply Sensitivity Current-Mode Relaxation Oscillator

A 0.26-Pj·k2 2400-Μm2 Digital Temperature Sensor in 55-Nm CMOS

A CMOS Relaxation Oscillator with Process and Temperature Variation Compensation.

An Untrimmed BJT-Based Temperature Sensor with Dynamic Current-Gain Compensation in 55-Nm CMOS Process

A 0.8V Capacitively-Biased BJT-Based Temperature Sensor with an Inaccuracy of ±0.4°C ($\mathbf{3}\mathbf{\sigma}$) from −40°C to 125°C in 22nm CMOS

A 1.2V Self-Referenced Temperature Sensor with a Time-Domain Readout and a Two-Step Improvement on Output Dynamic Range

An Energy-Efficient BJT-Based Temperature Sensor with +/- 0.8 degrees C (3 sigma) Inaccuracy from-50 to 150 degrees C

A CMOS Temperature Sensor with Versatile Readout Scheme and High Accuracy for Multi-Sensor Systems

A 1.3-Μw −0.3/+0.27°C Inaccuracy Fully-integrated Temperature Sensor Based on a Pre-Charge Relaxation Oscillator for IoT Applications

A Dynamic-Biased Resistor-Based CMOS Temperature Sensor with a Duty-Cycle-Modulated Output

An Ultra-Low-power CMOS Temperature Sensor for RFID Applications

An Ultra-Low-Power Temperature Sensor with an Accuracy of +0.6/-1 °C From−30 °C to 90 °C

A 40 nW 32.7 kHz CMOS Relaxation Oscillator with Comparator Offset Cancellation for Ultra-Low Power applications

Design of an Ultralow-Power CMOS Relaxation Oscillator for Piezoresistive Pressure Sensor

A Low-Power CMOS Smart Temperature Sensor for RFID Application

A Near-Zero-Power Temperature Sensor with ±0.24 °C Inaccuracy Using Only Standard CMOS Transistors for IoT Applications

A 1770- $\mu$ M 2 Leakage-Based Digital Temperature Sensor with Supply Sensitivity Suppression in 55-Nm CMOS

A 12.5-ppm/°C 1.086-nW/kHz Relaxation Oscillator with Clock-Gated Discrete-Time Comparator in 22nm CMOS Technology

A novel low power wide supply voltage range CMOS temperature sensor with 0.2/0.5°C error from -20°C to 60°C