Abstract:A number of CO2 capture-enabled power generation technologies have been proposed to address the negative environmental impact of CO2 emission. One important barrier to adopting these technologies is the associated energy penalty. Chemical-looping Combustion (CLC) is an oxy-combustion technology that can significantly lower this penalty. It utilizes an oxygen carrier to transfer oxygen from air/oxidizing stream in an oxidation reactor to the fuel in a reduction reactor. Conventional CLC reactor designs employ two separate reactors, with metal/metal oxide particles circulating pneumatically in-between. One of the key limitations of these designs is the entropy generation due to reactor temperature difference, which lowers the cycle efficiency. Zhao et al. (Zhao et al., 2014; Zhao and Ghoniem, 2014) proposed a new CLC rotary reactor design, which overcomes this limitation. This reactor consists of a single rotating wheel with micro-channels designed to maintain thermal equilibrium between the fuel and air sides. This study uses three thermodynamic models of increasing fidelity to demonstrate that the internal thermal coupling in the rotary CLC reactor creates the potential for improved cycle efficiency. A theoretical availability model and an ideal thermodynamic cycle model are used to define the efficiency limits of CLC systems, illustrate the impact of reactor thermal coupling and discuss relevant criteria. An Aspen Plus model of a regenerative CLC cycle is then used to show that this thermal coupling raises the cycle efficiency by up to 2% points. A parametric study shows that efficiency varies inversely with pressure, with a maximum of 51% at 3 bar, 1000 C and 60% at 4 bar, 1400 C. The efficiency increases with CO2 fraction at high pressure ratios but exhibits a slight inverse dependence at low pressure ratios. The parametric study shows that for low purge steam demand, steam generation improves exhaust heat recovery and increases efficiency when an appropriate steam production strategy is adopted. (C) 2015 Elsevier Ltd. All rights reserved.

Design and Techno-Economic Optimization of a Rotary Chemical Looping Combustion Power Plant with CO2 Capture

Analysis of Thermally Coupled Chemical Looping Combustion-Based Power Plants with Carbon Capture

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

Rotary Bed Reactor for Chemical-Looping Combustion with Carbon Capture. Part 1: Reactor Design and Model Development

Power Generation from Coke Oven Gas Using Chemical Looping Combustion: Thermodynamic Simulation

Technical Economic and Environmental Analysis of Chemical Looping Versus Oxyfuel Combustion for NGCC Power Plant

A Reduced Fidelity Model for the Rotary Chemical Looping Combustion Reactor

Concept Design, Parameter Analysis, and Thermodynamic Evaluation of a Novel Integrated Gasification Chemical-Looping Combustion Combined Cycle Power Generation System

Pinch combined with exergy analysis for heat exchange network and techno-economic evaluation of coal chemical looping combustion power plant with CO<sub>2</sub> capture

System-level feasibility analysis of a novel chemical looping combustion integrated with electrochemical CO2 reduction

Synthesis of Methanol From a Chemical Looping Syngas for the Decarbonization of the Power Sector

Numerical Investigation of a 1MW Full-Loop Chemical Looping Combustion Unit with Dual CFB Reactors

Optimization of Post Combustion CO2 Capture from a Combined-Cycle Gas Turbine Power Plant via Taguchi Design of Experiment

Design of a rotary reactor for chemical-looping combustion. Part 1: Fundamentals and design methodology

Rotary Bed Reactor for Chemical-Looping Combustion with Carbon Capture. Part 2: Base Case and Sensitivity Analysis

Efficient Cycles for Carbon Capture CLC Power Plants Based on Thermally Balanced Redox Reactors

Advanced power cycles for coal-fired power plants based on calcium looping combustion: A techno-economic feasibility assessment

Chemical Looping: A Flexible Platform Technology for CH4 Conversion Coupled with CO2 Utilization

Three-dimensional Simulation of a Gas-Fueled Chemical Looping Combustion System with Dual Circulating Fluidized Bed Reactors

CFD Modelling of the Fuel Reactor of a Chemical Loping Combustion Plant to Be Used with Biomethane

Bioenergy with Carbon Capture and Storage (BECCS) developed by coupling a Pressurised Chemical Looping combustor with a turbo expander: How to optimize plant efficiency