Abstract:A novel design of the gas inlet system in a diamond microwave plasma chemical vapor deposition growth chamber has been reported in this paper. The design is targeting for high-quality, high-speed, and high-efficiency diamond material fabrication. By introducing a gas inlet hole into the susceptor, we expand the ways of gas introduction for diamond growth. After extensive numerical and experimental investigation, we have found that the introduction of methane and doping gas inlet from the hole of below while the hydrogen from the top is feasible for realizing the target. The growth and doping species could be confined around the substrate, making efficient usage of the precursors. The plasma state change caused by the difference of the gas inlet modes has been ascribed to the resulted gas distribution in the chamber. The measured growth rate has been increased to 32 μm/h, which is 16 times higher than traditional gas inlet configuration. Meanwhile, a large improvement of the nitrogen doping concentration has been achieved. Besides, with the increase of growth rate and nitrogen incorporation efficiency, the crystal quality and surface morphology keep in an acceptable degree. In this mode, the dual gas flow system can perfectly solve the contradiction among the crystal quality, growth rate, and doping efficiency, commonly existing during the material fabrication process, the chamber contamination could be significantly suppressed due to the constrained distribution of methyl and doping species, making the fabrication cost much lower. The results of repetitive experiments indicate that other residual impurities present in the chamber of MPCVD could likely regulate the threshold concentration of nitrogen required for accelerating the growth rate during the nitrogen doped diamond growth, which have a significant effect on the diamond growth.

Tetramethysilane-assisted Enhancement of Diamond Nucleation on Silicon Substrate

Bright silicon vacancy centers in diamond/SiC composite films synthesized by a MPCVD method

Nucleation growth mechanism of diamond on 4H-SiC substrate by microwave plasma chemical vapor deposition

Discharge Induced Enhancement of Diamond Nucleation on Si Via Hot Filament Chemical Vapor Deposition

Enhanced Nucleation and Growth of Diamond Film on Si by CVD Using a Chemical Precursor

Formation Mechanism of SiV in Diamond from Unintentional Silicon Doping by Microwave Plasma Chemical Vapor Deposition

Heteroepitaxial diamond growth on 4H-SiC using microwave plasma chemical vapor deposition

Experimental Approach to the Mechanism of the Negative Bias Enhanced Nucleation of Diamond on Si Via Hot Filament Chemical Vapor Deposition

Diamond Nucleation on Unscratched Silicon Substrates Coated with Various Non-Diamond Carbon Films by Microwave Plasma-Enhanced Chemical Vapor Deposition

Electron-Emission-Enhanced Diamond Nucleation on Si by Hot Filament Chemical Vapor Deposition

Reaction mechanism of Ti3SiC2 formed on the diamond

Selected-Area Diamond Deposition On Si Substrates Pretreated In Different Ways

Diamond Nucleation on Smooth Si3n4-Coated Substrate

Deposition of highly adhesive nanocrystalline diamond films on Ti substrates via diamond/SiC composite interlayers

Interface Modulation for the Heterointegration of Diamond on Si

Si-doped Diamond Films Prepared by Chemical Vapour Deposition

Si+ Implantation: A Pretreatment Method for Diamond Nucleation on a Si Wafer

An innovative gas inlet design in a microwave plasma chemical vapor deposition chamber for high-quality, high-speed, and high-efficiency diamond growth

Growth of Diamond Films on Si3n4 Coated Silicon Substrates

Effect of Silicon Doping in Cvd Diamond Films from Microcrystalline to Nanocrystalline on Wc-Co Substrates

High Efficiency of Boron Doping and Fast Growth Realized with a Novel Gas Inlet Structure in Diamond Microwave Plasma Chemical Vapor Deposition System