Abstract:Mesostructured silica SBA-15 materials with different structural parameters, such as pore size, pore volume, and wall thickness, etc., were prepared by varying the postsynthesis hydrothermal treatment temperature and adding inorganic salts. The hydrothermal stabilities of these materials in steam (100% water vapor) were systematically investigated using a variety of techniques including powder X-ray diffraction, transmission electron microscopy, nitrogen sorption, and (29)Si solid-state NMR. The effect of the pore size, microporosity or mesoporosity, and wall thickness on the stability was discussed. The results show that all of the SBA-15 materials have a good hydrothermal stability under steam of 600 degrees C for at least 24 h. N(2) sorption measurements show that the Brumauer-Emmett-Teller surface area of SBA-15 materials is decreased by about 62% after treatment under steam at 600 degrees C for 24 h. The materials with thicker walls and more micropores show relatively better hydrothermal stability in steam of 600 degrees C. Interestingly, we found that the microporosity of the mesostructured silica SBA-15 is a very important factor for the hydrothermal stability. To the materials with more micropores, the recombination of Si-O-Si bonds during the high-temperature steam treatment may not cause direct destruction to the wall structure. As a result, SBA-15 materials with more micropores show better stability in pure steam of 600 degrees C. Nevertheless, these materials are easily destroyed in steam of 800 degrees C for 6 h. Two methods to effectively improve the hydrothermal stability are introduced here: one is a high-temperature treatment, and another is a carbon-propping thermal treatment. Thermal treatment at 900 degrees C can enhance the polymerization degree of Si-O-Si bonds and effectively improve the hydrothermal stability of these SBA-15 materials in 800 degrees C steam for 12 h. But, this approach will cause very serious shrinkage of the mesopores, resulting in smaller pore diameter and low surface area. A carbon-propping thermal treating method was employed to enhance the polymerization of Si-O-Si bonds and minimize the serious shrinkage of mesopores at the same time. It was demonstrated to be an effective method that can greatly improve the hydrothermal stability of SBA-15 materials in 800 degrees C steam for 12 h. Furthermore, the SBA-15 materials obtained by using the carbon-propping method possess larger pores and higher surface area after the steam treatment at 800 degrees C compared to the materials from the direct thermal treatment method after the steam treatment.

Transformation Behavior of Gibbsite to Boehmite by Steam-Assisted Synthesis

Facile Synthesis of Hierarchical Flower-Like Γ-Alooh Films Via Hydrothermal Route on Quartz Surface

Reactive Crystallization Kinetics Study of Boehmite in Ammonia Solution by Adding Ammonium Aluminum Sulfate

Vaporthermal-driven rapid transformation of commercial gibbsite to rhombic boehmite flakes

Hydrothermal Transformation of Bayerite to Boehmite

Controlling Crystal Transformation Between Zeolite Zsm-5 and Mordenite Without Organic Structure-Directing Agent

Size and Morphology Controlled Synthesis of Boehmite Nanoplates and Crystal Growth Mechanisms

Boehmite Preparation via Alditols-Interacting Transformation of Metastable Intermediates in Al–H2O Reaction Crystallization

Crystallization Process of Zeolite ZSM-5 and Zeolite ZSM-35 in a Special Autoclave

Hydrothermal stability of gamma-Al 2 O 3 supports varied with crystal plane orientation of pseudo-boehmite precursor

Synthesis and Characterization of Gibbsite Nanostructures

Morphology Preservation and Crystallinity Improvement in the Thermal Conversion of the Hydrothermal Synthesized Mgbo2(Oh) Nanowhiskers to Mg2b2o5 Nanowhiskers

A Facile Temperature-Controlled "Green" Method to Prepare Multi-kinds of High-Quality Alumina Hydrates via a Ga-In-Sn-Alloyed Aluminum-Water Interface Reaction.

Different roles of CNTs in hierarchical HZSM-5 synthesis with hydrothermal and steam-assisted crystallization

Hydrothermal Preparation Of Boehmite Nanorods By Selective Adsorption Of Sulfate

Understanding Effect of Wall Structure on the Hydrothermal Stability of Mesostructured Silica SBA-15.

A readily monitored and controllable hydrothermal system for the facile, cost-effective transformation of FGD gypsum to calcium sulfate hemihydrate whiskers

A new route to synthesis of γ-alumina nanorods

One-step preparation of high-purity boehmite by the effect of sugar alcohol in the aluminum-water reaction

Crystallization Behavior of ZSM-35 Zeolite in Seed-Assisted VPT Synthesis System

A novel method for the synthesis of nano-sized BaAl2O4 with thermal stability