Abstract:After nearly half a century of research into the bias temperature instability (BTI), two classes of models have emerged as the strongest contenders: one class of models, the reaction-diffusion models, is built around the idea that hydrogen is released from the interface and that it is the diffusion of some form of hydrogen that controls both degradation and recovery. While many different variants of the reaction-diffusion idea have been published over the years, the most commonly used recent models are based on non-dispersive reaction rates and non- dispersive diffusion. The other class of models is based on the idea that degradation is controlled by first-order reactions with widely distributed (dispersive) reaction rates. We demonstrate that these two classes give fundamentally different predictions for the stochastic degradation and recovery of nanoscale devices, therefore providing the ultimate modeling benchmark. Using de- tailed experimental time-dependent defect spectroscopy (TDDS) data obtained on such nanoscale devices, we investigate the compatibility of these models with experiment. Our results show that the diffusion of hydrogen (or any other species) is unlikely to be the limiting aspect that determines degradation. On the other hand, the data are fully consistent with reaction-limited models. We finally argue that only the correct understanding of the physical mechanisms leading to the significant device-to-device variation observed in the degradation in nanoscale devices will enable accurate reliability projections and device optimization.

Bias Temperature Instability Model Using Dynamic Defect Potential for Predicting CMOS Aging

Bias Temperature Instability of MOSFETs: Physical Processes, Models, and Prediction

Accelerated Aging in Analog and Digital Circuits with Feedback

A Machine Learning Based Reliability Analysis of Negative Bias Temperature Instability (NBTI) Compliant Design for Ultra Large Scale Digital Integrated Circuit

Investigation on NBTI-induced dynamic variability in nanoscale CMOS devices: Modeling, experimental evidence, and impact on circuits.

Factors for Negative Bias Temperature Instability Improvement in Deep Sub-Micron CMOS Technology

Compact Negative Bias Temperature Instability Model for Silicon Nanowire MOSFET (SNWT) and Application in Circuit Performance Simulation

Modeling of PMOS NBTI Effect Considering Temperature Variation

NBTI in Nanoscale MOSFETs - The Ultimate Modeling Benchmark

Modeling Of Nbti Stress Induced Hole-Trapping And Interface-State-Generation Mechanisms Under A Wide Range Of Bias Conditions

Model of NBTI combined with mobility degradation

Compact reliability model for degradation of advanced p-MOSFETs due to NBTI and hot-carrier effects in the circuit simulation

Temperature-Aware NBTI Modeling Techniques in Digital Circuits.

Predictive As-grown-generation Model for NBTI of Advanced CMOS Devices and Circuits

Negative-Bias Temperature Instability in Gate-All-Around Silicon Nanowire Mosfets: Characteristic Modeling and the Impact on Circuit Aging

Predictive As-Grown-Generation (A-G) Model For Bti-Induced Device/Circuit Level Variations In Nanoscale Technology Nodes

Synergistic Effect of BTI and Process Variations on the Soft Error Rate Estimation in Digital Circuits

Advanced Compact Modeling for Transistor Aging: Trap-based Approaches and Mixed-mode Coupling

A Device-Circuit Aging Simulation Framework Integrating Trap-Based Models and Sensitivity Analysis for FinFET Technology

A novel negative bias temperature instability model for nanoscale finfet

New-Age : A Negative Bias Temperature Instability-Estimation Framework for Microarchitectural Components