Abstract:The room temperature oxidation process of thin TiNx films, grown by DC reactive magnetron sputtering, was studied by in-situ and real time spectroscopic ellipsometry, X-ray reflectivity, Auger electron spectroscopy, X-ray photoelectron spectroscopy and stress measurements. The films were deposited at various negative bias voltages (Vb) in order to vary the TiNx stoichiometry and then exposed to several gases and to air at room temperature. The oxidation rate was found to depend strongly on Vb and thus on film stoichiometry. Fast oxidation was observed in films deposited at low |Vb|, that contain nitrogen which is weakly bonded to Ti and can be easily replaced by oxygen. At high |Vb| values (above −80 V) stoichiometric TiN films were developed, that were stable and not prone to oxidation. The results showed that oxidation takes place in the bulk of the film and can proceed up to about 10% transformation of titanium nitride into titanium oxide. The fastest step in the film oxidation mechanism is diffusion of oxygen along the columnar grain boundary structure, followed by the reaction of oxygen with the weakly bonded TiN. The results suggest that the oxidation process proceeds with different stages involving formation of TiON, followed by a slow stage of TiO2 formation. These microstructural changes are consistent with the evolution of compressive stresses in the films and the increase in film density and thickness and the decrease in surface roughness as determined by X-ray reflectivity.

Ageing effects on electrical resistivity of Nb-doped TiO2 thin films deposited at a high rate by reactive DC magnetron sputtering

Controllable Optical and Electrical Properties of Nb Doped TiO2 Films by RF Sputtering

Effect of Nb Doping Concentration on Transparent Conductivity of TiO2 Films Fabricated by Sol-Gel Method

Microstructural and Electrical Resistivity of TiN Electrode Films Prepared by Direct Current (DC) Reactive Magnetron Sputtering

The Sintering Trajectory and Electrical Properties of Niobium‐Doped Titania Sputtering Targets

Structural, Optical and Electrical Properties of Sputtered Nb Doped TiO2 Transparent Conductive Films

Investigation of microstructure evolution in Pt-doped TiO2 thin films deposited by rf magnetron sputtering

Microstructures and Properties of N-Doped TiO_2 Films Grown by Dielectric Barrier Discharge Chemical Vapor Deposition

Structural and Optoelectrical Properties of Nb-TiO2 Films Fabricated by Low-Energy Magnetron Sputtering and Post-Annealing

Improving the Electrical Properties of Niobium-Doped Titania Sputtering Targets by Sintering in Oxygen-Deficient Atmospheres

Reactive Twin-Magnetron Sputtering Of Ti1-Xnbxo2 Transparent Conducting Oxide Films

Effects of Annealing on TiN Thin Film Growth by DC Magnetron Sputtering

Temperature dependent dielectric properties and AC conductivity studies on titanium niobium oxide (TiNb2O7) thin films

Influence of Deposition Parameters on Structural and Electrochemical Properties of Ti/Ti2N Films Deposited by RF-Magnetron Sputtering

Influence of Thickness on the Electrical Properties of BaTiO3films Deposited on Ni Substrates by Radio-Frequency Magnetron Sputtering

Study of nitrogen ion doping of titanium dioxide films

Room temperature oxidation behavior of TiN thin films

Microstructure and Mechanical Properties of Co-Deposited Ti-Ni Films Prepared by Magnetron Sputtering

Influence of N2 Partial Pressure on Mechanical Properties of (ti,al)n Films Deposited by Reactive Magnetron Sputtering

Effects of Nitrogen Content on Microstructures and Mechanical Behavior of (titacrmonb)nx Films

Effects of nitrogen composition on the resistivity of reactively sputtered TaN thin films