Abstract:Post deposition annealing of molecular layer-deposited (MLD) hafnicone films was examined and compared to that of hafnium oxide atomic layer-deposited (ALD) films. Hafnicone films were deposited using tetrakis(dimethylamido)hafnium (TDMAH), and ethylene glycol and hafnia films were deposited using TDMAH and water at 120 °C. The changes in the properties of the as-deposited hafnicone films with annealing were probed by various techniques and then compared to the as-deposited and annealed ALD hafnia films. In situ X-ray reflectivity indicated a 70% decrease in thickness and ∼100% increase in density upon heating to 400 °C yet the density remained lower than that of hafnia control samples. The largest decreases in thickness of the hafnicone films were observed from 150 to 350 °C. In situ X-ray diffraction indicated an increase in the temperature required for crystallization in the hafnicone films (600 °C) relative to the hafnia films (350 °C). The changes in chemistry of the hafnicone films annealed with and without UV exposure were probed using Fourier transformed infrared spectroscopy and X-ray photoelectron spectroscopy with no significant differences attributed to the UV exposure. The hafnicone films exhibited lower dielectric constants than hafnia control samples over the entire temperature range examined. The CF4/O2 etch rate of the hafnicone films was comparable to the etch rate of hafnia films after annealing at 350 °C. The thermal conductivity of the hafnicone films initially decreased with thermal processing (up to 250 °C) and then increased (350 °C), likely due to porosity generation and subsequent densification, respectively. This work demonstrates that annealing MLD films is a promising strategy for generating thin films with a low density and relative permittivity.

Physical Mechanism of Refractive Index Inhomogeneity of Hafnium Oxide Thin Film Prepared by Ion Beam Sputtering Technique

Microstructure Optimization and Optical and Interfacial Properties Modulation of Sputtering-Derived Hfo2 Thin Films by Tio2 Incorporation

Modulation of the structural and optical properties of sputtering-derived HfO2 films by deposition power

Optical and Mechanical Properties and Microstructures of Nb2O5, Ta2O5 and SiO2 Thin Films Prepared by Ion Beam Sputtering

Optical Properties Study of Silicon Oxynitride Films Deposited by RF Magnetron Sputtering

Annealing Temperature Dependent Microstructure and Optical Properties of HfxTi1-xO2 Thin Films

Effect of Oxygen Flow on the Optical Properties of Hafnium Oxide Thin Films by Dual-Ion Beam Sputtering Deposition

Characteristics of Nb2 O5 Thin Films Deposited by Ion Beam Sputtering

Microstructure, Optical Properties, and Optical Resonators of Hf1-Xtixo2 Amorphous Thin Films

Energy Band Properties of Hafnium Oxide Thin Films Fabricated by Ion Beam Sputtering Technique

Refractive Indexes of Oxidized Thin Films Deposited by Ion Beam Sputtering

Refractive index of thin films of SiO2, ZrO2, and HfO2 as a function of the films' mass density

Effect of Heat Treatment on Properties of HfO2 Film Deposited by Ion-Beam Sputtering

Oblique Angle Deposition of HfO2 Thin Films: Investigation of Elastic and Micro Structural Properties

Nanostructuring Hfo2 Thin Films As Antireflection Coatings

The refractive index of homogeneous SiO2 thin films

Low energy Xe ion beam engineering in optical, structural and morphological properties of hafnium oxide thin films grown by atomic layer deposition technique

Structure and Dielectric Properties of HfO2 Thin Films

Reducing optical loss of dual-ion beam sputtered HfO2 films via optimization of coating and annealing parameters

Chemical, Structural, and Electrical Changes in Molecular Layer-Deposited Hafnicone Thin Films after Thermal Processing

Structural, optical and phonon properties of hafnium oxynitride thin films synthesized using plasma-enhanced atomic layer deposition