Abstract:The combination of non-thermal plasma (NTP) and transition metal catalysts is an alternative method for reducing tar derived from biomass gasification, converting it to a mix of mainly H-2 and CO (syngas). In this study, Ni-and Fe-based steam reforming catalysts supported on CaO, SiO2,gamma-Al2O3 and ZSM-5 were combined with a coaxial dielectric barrier discharge (DBD) plasma reactor for converting toluene, selected as a simple tar model compound. The catalysts supported by ZSM-5 showed the best potential for increasing toluene conversion, promoting the formation of syngas, reducing the production of undesirable liquid by products (such as benzene and ethylbenzene) and corroborating the resistance to catalyst deactivation caused by sintering and carbon deposition. Toluene cracking has been investigated in a plasma-alone (PA), a post-plasma catalysis (PPC) and an in-plasma catalysis (IPC) system. The IPC system exhibited the highest toluene conversion efficiency and selectivity for syngas formation, compared with the PA and PPC systems. A maximum toluene conversion of 86.5% was achieved in the IPC system over Ni/ZSM-5, together with a maximum gas selectivity (63.3% for H-2, 18.2% for CO, and 4.6% for CH4), and a minimum selectivity to the undesirable liquid by-products (2.5% for benzene and 0.66% for ethylbenzene and a low carbon selectivity of 6.7%). In addition, the reaction mechanism was significantly different in the IPC system from those in the PA and PPC system, since the catalyst in the IPC system might influence the discharge properties and the reaction between excited and short lifetime reactive plasma species (OH center dot, O center dot, N-2(*)) and toluene and its intermediates. Finally, a mechanism of toluene cracking has been proposed, after analysis of the gas and liquid products and characterization of the fresh and used catalysts.

Steam Reforming of Toluene As Model Biomass Tar to H2-rich Syngas in a DBD Plasma-Catalytic System

Enhanced Reforming of Mixed Biomass Tar Model Compounds Using a Hybrid Gliding Arc Plasma Catalytic Process

Plasma-assisted catalytic reforming of toluene to hydrogen rich syngas

Steam reforming of toluene as biomass tar model compound in a gliding arc discharge reactor

Removal of tar derived from biomass gasification via synergy of non-thermal plasma and catalysis

Plasma-enabled Catalytic Steam Reforming of Toluene As a Biomass Tar Surrogate: Understanding the Synergistic Effect of Plasma Catalysis

Plasma-enhanced Steam Reforming of Different Model Tar Compounds over Ni-based Fusion Catalysts

Plasma Reforming of Biomass Gasification Tars Using Mixed Naphthalene and Toluene As Model Compounds

Removal of Toluene As a Biomass Tar Surrogate in a Catalytic Nonthermal Plasma Process

Steam Reforming of Biomass Tar Model Compounds over Monolithic Catalysts

Dry Reforming of Model Biomass Pyrolysis Products to Syngas by Dielectric Barrier Discharge Plasma

Steam Reforming of Α-Methylnaphthalene As a Model Compound of Biomass Tar over Ni-based Catalyst for Hydrogen-Rich Gas

Plasma-Catalytic Reforming of Naphthalene and Toluene as Biomass Tar over Honeycomb Catalysts in a Gliding Arc Reactor

Steam reforming of toluene as model compound of biomass pyrolysis tar for hydrogen

Photothermal Steam Reforming: A Novel Method for Tar Elimination in Biomass Gasification

Plasma Reforming of Naphthalene As a Tar Model Compound of Biomass Gasification

Enhanced H 2 -Rich Gas Production via Steam Reforming of Toluene over Ni-Based Hydrotalcite-Derived Catalysts at Low Temperature

Steam Reforming of Toluene and Naphthalene As Tar Surrogate in a Gliding Arc Discharge Reactor.

Plasma-Catalytic CO2 Reforming of Toluene over Hydrotalcite-Derived NiFe/(Mg, Al)O X Catalysts.

Low-Temperature Steam Reforming of Toluene and Biomass Tar over Biochar-Supported Ni Nanoparticles

Experimental and kinetic modeling study of tar partial oxidative reforming by dielectric barrier discharge plasma using toluene as a model compound