Abstract:Sample time error can degrade the performance of time-interleaved analog to digital converters (TIADCs). A fully digital background algorithm is presented in this paper to estimate and correct the timing mismatch errors between four interleaved channels, together with its hardware implementation. The proposed algorithm provides low computation burden and high performance. It is based on the simplified representation of the coefficients of the Lagrange interpolator. Simulation results show that it can suppress error tones in all of the Nyquist band. Results show that, for a four-channel TIADC with 10-bit resolution, the proposed algorithm improves the signal to noise and distortion ratio (SNDR) and spurious-free dynamic range (SFDR) by 19.27 dB and 35.2 dB, respectively. This analysis was done for an input signal frequency of (0.09f_s). In the case of an input signal frequency of (0.45f_s), an improvement by 33.06 dB and 43.14 dB is respectively achieved in SNDR and SFDR. In addition to the simulation, the algorithm was implemented in hardware for real-time evaluation. The low computational burden of the algorithm allowed an FPGA implementation with a low logic resource usage and a high system clock speed (926.95 MHz for four channel algorithm implementation). Thus, the proposed architecture can be used as a post-processing algorithm in host processors for data acquisition systems to improve the performance of TIADC.

Calibration of Timing Mismatch in a Two-Channels Time-Interleaved ADC Based on Testing Signal and Its Verification on FPGA

A Calibration Technique Based on Frequency-Domain Characteristics for Pipelined ADCs

Modeling of digital background calibration with signal-dependent dithering for a 14-bit, 100-MS/s pipelined ADC

Modeling of a 14-bit, 100-MS/s pipelined ADC with digital nonlinearity calibration

An All−Digital Timing Mismatch Calibration Algorithm Based on Reference Channel for TIADC

A Novel Autocorrelation-Based Timing Mismatch C Alibration Strategy in Time-Interleaved ADCs

A Fast Combination Calibration of Foreground and Background for Pipelined ADCs

A Wideband Timing Mismatch Calibration Design for Time-Interleaved Analog-to-Digital Converters with Fast Convergence

Digital background calibration algorithm and its FPGA implementation for timing mismatch correction of time-interleaved ADC

A Calibration Scheme for a 800-Ms/s 14 Bit Pipelined ADC in 28-Nm CMOS

The fast time-interleaved ADC channel mismatch calibration method based on equivalent sampling and dynamic reference point

A 14-Bit 200-Ms/s Time-Interleaved Adc with Sample-Time Error Calibration

A Mixed Sample-Time Error Calibration Technique in Time-Interleaved ADCs

An improved wide-range, low-complexity, fully-parallel digital background timing mismatch calibration method for dual-channel TIADC based on perfect reconstruction filter bank

A Background Timing Skew Calibration Technique In Time-Interleaved Adcs

TI-ADC multi-channel mismatch estimation and calibration in ultra-high-speed optical signal acquisition system

A charge pump based timing-skew calibration for time-interleaved ADC

A Maximum-Likelihood-Estimation-Based Digital Background Calibration Technique for Interstage Gain Error in Pipelined ADCs

A Sample-Time Error Calibration Technique in Time-Interleaved ADCs with Correlation-Based Detection and Voltage-Controlled Compensation

High-Speed and Time-Interleaved ADCs Using Additive-Neural-Network-Based Calibration for Nonlinear Amplitude and Phase Distortion

An Improved All-Digital Background Calibration Technique for Channel Mismatches in High Speed Time-Interleaved Analog-to-Digital Converters