Abstract:The Ni-Fe-based superalloy GH4169 (Inconel718) is widely used for several critical gas-turbine components which are hot forged. Its microstructure and property are sensitive to the parameter adjustment during hot working process. To obtain required low-cycle fatigue and fracture properties, it is essential that the microstructure is controlled during preheating and heat treatment. The evolution of non-uniform microstructure during hot working is more complicated than that of uniform microstructure. On the other hand, various secondary phases can be observed in GH4169 alloy, thus it is important to investigate the effect of secondary phases on the microstructure evolution during forging process. In this work, the mechanisms of non-uniform microstructure evolution in GH4169 alloy were studied by analyzing the evolution of secondary phases, grain boundary misorientation, grain size and interactions of dislocation. It is found that the volume fraction of 8 phase increases with the increasing of temperature and heating time at the lower temperature. While at the higher temperature, it decreases monotonously with the temperature increasing, but increases first and then decreases to stable value with time increasing. The pinning effect of secondary phases in GH4169 alloy can be concluded that the gamma '' phase and 8 phase precipitated within the grains retain movement of dislocation, the 8 phase precipitated at the grain boundary hinders the nucleation and growth of recrystallized grains, and the carbides limits the grain growth. The frequency of low angle grain boundary decreases with temperature and time increasing, and the mobility of low angle grain boundary increases with temperature increasing. The uniformity of microstructure and the size of equaxied subgrain increases with heating temperature and time increasing. Continuous recrystallization of elongated grain occurs at specific conditions. The mechanisms of non-uniform microstructure evolution during heating process can be concluded as sub grain growth, recrystallized grain growth, and anneal twinning nucleation and growth. The recrystallized grains are formed by the growth of subgrains conducted by the rotation of low angle grain boundary and the movement of dislocation. When the grain growth is pinned, the mechanisms for the energy dissipation is the nucleation and growth of anneal twinning. And the growth of anneal twinning promotes the generation of low angle grain boundaries at the tip of partial anneal twinning.

Unraveling the Formation Mechanism of Abnormally Large Grains in an Advanced Polycrystalline Nickel Base Superalloy

Abnormal Grain Growth: A Potential Way to Construct Gradient Structure

Formation Mechanism of Abnormally Large Grains in a Polycrystalline Nickel-Based Superalloy During Heat Treatment Processing

Refining Micron-Sized Grains to Nanoscale in Ni-Co Based Superalloy by Quasistatical Compressive Deformation at High Temperature

Strain Amount Dependent Grain Size And Orientation Developments During Hot Compression Of A Polycrystalline Nickel Based Superalloy

Controlling Grain Size Via Dynamic Recrystallization in an Advanced Polycrystalline Nickel Base Superalloy

Mechanisms of Non-Uniform Microstructure Evolution in Gh4169 Alloy During Heating Process

The Microstructure Characteristic and Its Influence on the Stray Grains of Nickel-based Single Crystal Superalloys Prepared by Laser Directed Energy Deposition

Effect of Hot Deformation Parameters on Grain Refinement of an As-Cast Ni-Based Superalloy

Investigation of Plastic Deformation Behavior of a Grain-Size Gradient Nickel-Based Superalloy

Abnormal grain growth in the Ni-based wrought superalloy GH4698 bar during heat treatment

Deformation Behavior of Nickel-Based Superalloys with Bimodal Γ′ Size Distribution Studied by In-Situ Neutron Diffraction Combined with Evpsc Modeling

Cellular Automata Simulation of Grain Growth of Powder Metallurgy Nickel-Based Superalloy

Microstructure Evolutions and Nucleation Mechanisms of Dynamic Recrystallization of A Powder Metallurgy Ni-Based Superalloy During Hot Compression

Description of Grain Evolution Behaviors in Mesoscale During Electrical-Thermal-Mechanical Coupling Compression Processes for Ni80A Superalloy

Effects of Strain Amount and Strain Rate on Grain Structure of a Novel High Co Nickel-Based Polycrystalline Superalloy

Deformation Mechanisms of Primary Γ′ Precipitates in Nickel-Based Superalloy

Probing the formation mechanism of hierarchical microstructures in experimental Ni-based superalloys

Microstructure Evolution and Dynamic Recrystallization Mechanism Induced by Grinding of Ni-based Single Crystal Superalloy

Study on the Dynamic Recrystallization Mechanisms Tailored by Dislocation Substructures of a Coarse Grained Co-free Nickel-Based Superalloy

Competitive Grain Growth Mechanism in Three Dimensions During Directional Solidification of A Nickel-Based Superalloy